Well, I hate to suggest assuming anything, since only the cam dictates the firing order. And a cam can be changed. Someone could have taken an old 302/5.0 and put a 351/5.0HO cam in it very easily.
But since you bought it as a late model engine, and everything else appears to be that way, short of looking at the crank I.D. numbers, might as well go for the new balancer and flywheel/flexplate.
That's what bowsher was saying. They BOTH have to match the crankshaft. Not just the damper. So you're going to be pulling the transmission too, to replace the flywheel. If you didn't intend to already that is.
I think I remember you mentioning that the one that came with the new engine looked too small. Very possible because many of those engines were in cars, that would have had the 157 tooth flywheel. Your truck application would normally have used a 164 tooth version. But either will bolt on, and it depends on what bellhousing you use. If a truck bellhousing meant for an 11" clutch, you would want the larger version. Larger is better in this case, as long as it fits.
One of the replies in your other thread mentioned Damper Dudes. They're in the business of re-balancing and maybe even doing custom dampers.
When you re-balance is when yours is either in such good shape it would be a waster to throw it out, or more importantly, it's one of the only ones you could find that would line up with all the pullies.
Otherwise, not sure what damper you're going to need by part number. Only that you absolutely need a 50oz imbalance damper.
Paul