amc78cj7
Sr. Member
Bought and installed new greasable Moog Ball joints today for our '77 D44. Now I'm trying to install the knuckle on the housing yoke and running into problems. First, there are two sets of instructions that came with the two ball joints that have different recommended torque.
Here are the instuctions I TRIED to follow
1) tighten lock nut on lower ball joint to 70 ft.lbs (Unfortunately the stud starts to spin as soon as the lock thread hits the stud so you can't torque it down). To keep it from spinning I drew the balljoints into the sleeves with a C-clamp on the knuckle).
2) Torque upper spanner sleeve to 70 ft lbs (I did this, but at least 50% of spanner sleeve is below the Yoke treads now).
3) Torque upper castle nut to 100 ft lbs (Done)
4) (and this is only in one set of instructions but not the other) Torque lower ball joint to 120 ft. lbs. (This cannot be accomplished because the lower ball joint is spinning again.
HELP!
Here are the instuctions I TRIED to follow
1) tighten lock nut on lower ball joint to 70 ft.lbs (Unfortunately the stud starts to spin as soon as the lock thread hits the stud so you can't torque it down). To keep it from spinning I drew the balljoints into the sleeves with a C-clamp on the knuckle).
2) Torque upper spanner sleeve to 70 ft lbs (I did this, but at least 50% of spanner sleeve is below the Yoke treads now).
3) Torque upper castle nut to 100 ft lbs (Done)
4) (and this is only in one set of instructions but not the other) Torque lower ball joint to 120 ft. lbs. (This cannot be accomplished because the lower ball joint is spinning again.
HELP!











