• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Electrically Dead Bronco Help!

dirtbikedad

Jr. Member
Joined
Jan 16, 2010
Messages
97
Loc.
Athens, AL
:(I was at Lowes the other evening. Started up the bronco to go home. Started and was running ok. Turned on headlights and it immediately died!
Seemed to have no electrical output at all to headlights or ignition switch now.
Jumped across starter solenoid and it turns over. Replaced voltage regulator and starter solenoid as connections looked pretty corroded.
Checked all the fuses in the fuse box and they are good. Could it be the headlight switch???

How do I remove the headlight switch from the dash to check it?
 

ransil

Bronco Guru
Joined
Sep 6, 2003
Messages
8,138
headlight will not cause a no start unless you have a dead short somewhere., you already noticed corrosion near the battery I would start there. make sure your batt plus and ground cables are good. (Good is not using the bolt on type battery lugs )
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Where are the fusible links located??

Should be one attached to the starter solenoid in the thick black wire running towards the firewall. If it's bad you'll loose power to everything inside. You can get a replacement at most parts stores. Look for a 16 ga fusible link.

You could have a short to ground somewhere in the lighting or the fusible link may have been partially burned previously.
 

Justafordguy

Bronco Guru
Joined
Sep 26, 2009
Messages
6,255
I think a fusible link wire burned out, or a connector terminal smoked.

X2, I bet it's a burned fusible link. Like Viperwolf said it's in the main harness and connected to the starter solenoid on the large positive post. It just looks like a large wire but it's a fuse and burns inside if overloaded. Use a volt meter to test it. Make sure you find the short first before you burn up the new one.;D
 
Top