Glad it's updated and starting better! I think it's a great upgrade too.
A question is though, does your original starter relay mount to the wheel well directly facing the headers? Or is it mounted between the battery and fender, on the front face of the wheel well?
Even though, like the others have said, it's less likely to be a starter relay vs the starter or the cable, when they're mounted this way (like they are on many of the very early model EB's, heat is higher than on later models.
I would think that can have some mild effect then, especially on an older unit.
I wired it up according to the directions on this forum. So why wouldn't JBG put those directions in the box with the starter and why do they send it out with that jumper wire preinstalled?
Haven't seen the jumper wire you mention, but if it's the same as the one we now send ours out with, it's probably because they don't intend for you to wire it like the instructions say online. Instead they want you to simply wire it like they intended, with the original main starter cable from your fender-mounted relay directly to the large stud on the starter solenoid. No more changing of the position of that cable on the fender-mounted relay. Just leave it as is, and install the new starter.
That's only a guess however, as I have not seen their setup. But ours now includes a very short jumper between the large post and the small post on the starter-mounted solenoid.
Not for any particular performance change. More just to make it easier to wire for those that don't get online like here, and didn't understand the previous instructions that have you move the starter cable to the battery side of the relay, and put the new jumper wire between the relay and small post of the solenoid.
Saves time and wire.
Paul