lsukevinc
Full Member
When I bought my bronco in October, the previous owner had 3 aftermarket gauges installed under the radio (temp, oil pressure, and ammeter). The ammeter never worker but the temp and oil pressure did. I wanted to get all of the gauges working in the original cluster to work, so I have been working on each slowly one by one in order for all of them to work. This week, temp and oil pressure now officially work in the original cluster.
Last night I disconnected the ammeter and all hell broke loose. The previous owner had a wire coming from battery side of the solenoid to the positive side of the ammeter (picture 1). Then, a wire from the negative side of the gauge went back through the fire wall and tied into the voltage regulator/alternator wiring (picture 2). I am assuming this was how the original ammeter was wired? Once I disconnected the old ammeter, the bronco is dead….no lights, no horn, no power to the fuses, nothing. My battery is good ( I even hooked up my booster pack) and I do have 12 v to the battery side of the solenoid, but nowhere else. I tried to connect the wires back exactly as they came off and nothing, still dead.
My question is what to do with the wire going back to the voltage regulator/alternator wiring (picture 2)? Does it need to be grounded or hooked up 12 volts? The wire coming off the battery side of the solenoid I assume can go away since I am disconnecting this ammeter? Please help. I do have a good multi meter and a wiring diagram and understand the bronco wiring for the most part.
Last night I disconnected the ammeter and all hell broke loose. The previous owner had a wire coming from battery side of the solenoid to the positive side of the ammeter (picture 1). Then, a wire from the negative side of the gauge went back through the fire wall and tied into the voltage regulator/alternator wiring (picture 2). I am assuming this was how the original ammeter was wired? Once I disconnected the old ammeter, the bronco is dead….no lights, no horn, no power to the fuses, nothing. My battery is good ( I even hooked up my booster pack) and I do have 12 v to the battery side of the solenoid, but nowhere else. I tried to connect the wires back exactly as they came off and nothing, still dead.
My question is what to do with the wire going back to the voltage regulator/alternator wiring (picture 2)? Does it need to be grounded or hooked up 12 volts? The wire coming off the battery side of the solenoid I assume can go away since I am disconnecting this ammeter? Please help. I do have a good multi meter and a wiring diagram and understand the bronco wiring for the most part.











