Since you don't know where your timing is I would at least try playing with it a little bit. Advance it slightly to see how it runs. If it starts running rough, or makes pinging noises as you accelerate, back it off just slightly until it does not do it anymore.
If you have a stock cam, your vacuum could be up as high as 20 or 21 inches.
An old white mark is very likely close to the stock lines. In your case though, that could be somewhere near 6° BTDC, or even the zero degree mark. Most of my marks are at the zero line, then I work from there. No telling what your father-in-law was used to doing. Might have been stock, or he might have been just like one of us and put that line at an advanced point!;D
Only one way to find out...
If you're ever of a mind to, installing some timing tape from Mr Gasket makes tune-ups and testing a very easy proposition.
Paul