chuzie
Bronco Guru
- Joined
- Jul 21, 2006
- Messages
- 2,761
Never thought I would be posting about something as simple as a starter issue but here I am nonetheless.
351w Explorer EFI, 4R70W, Explorer reduction starter.
I have an intermittent starter issue. Occasionally it will make a single click and not crank. It sounds like maybe the pawl is extending but the motor is not moving. Either that or I am hearing the solenoid click.
12v to starter from battery with zero voltage drop on crank.
Signal wire at solenoid shows 6v on start. (6v drop). Disconnected from solenoid, the signal wire shows 12v on start. This tells me I have a bad wire somewhere.
Good grounds from battery and starter.
I eliminated the TRS by bypassing it and getting the same negative result.
I eliminated my ignition by bypassing the Explorer EFI harness and getting a positive result.
I am able to use a screwdriver to connect the signal post on the solenoid to the main battery lug on the starter and it starts fine.
It is my understanding the PINK wire (explorer) carries start signal from IGN to TRS. Then R/LtBl (T/R-98) from TRS to starter solenoid. Is there some other routing I am not aware of that I can check?
I should mention I did change the starter with no change.
What else am I missing here?
351w Explorer EFI, 4R70W, Explorer reduction starter.
I have an intermittent starter issue. Occasionally it will make a single click and not crank. It sounds like maybe the pawl is extending but the motor is not moving. Either that or I am hearing the solenoid click.
12v to starter from battery with zero voltage drop on crank.
Signal wire at solenoid shows 6v on start. (6v drop). Disconnected from solenoid, the signal wire shows 12v on start. This tells me I have a bad wire somewhere.
Good grounds from battery and starter.
I eliminated the TRS by bypassing it and getting the same negative result.
I eliminated my ignition by bypassing the Explorer EFI harness and getting a positive result.
I am able to use a screwdriver to connect the signal post on the solenoid to the main battery lug on the starter and it starts fine.
It is my understanding the PINK wire (explorer) carries start signal from IGN to TRS. Then R/LtBl (T/R-98) from TRS to starter solenoid. Is there some other routing I am not aware of that I can check?
I should mention I did change the starter with no change.
What else am I missing here?
Last edited:












