• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Axle spline question

MikeKC130J

Full Member
Joined
Dec 27, 2011
Messages
342
I have a 71 sport, did all the bronco come with the same size axles spline count? If not how would I know? With out pulling the axle out and counting?
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
And to add to what Mark said, there were still two variations for most years. A small-bearing axle and a large-bearing axle. This is for the wheel bearings out at the end of the axle and even though both used the same 28-spline count on the inner end, the outer end at the bearings were different sizes.

And just in case you need to know for future reference, different years also used different axle flange offsets (or brake offsets) where the end of the axle with the wheel studs was farther or closer to the bearing and housing end.
Stuff you were just dying to know I'm sure!

Here's some good info: https://www.wildhorses4x4.com/category/bronco_rear_axle now accompanied by recent Moab pics of some of our very own members here on classic for your visual enjoyment!;D

Paul
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
Been dealing with this question for over 20 years. Answer is still the same. Every early bronco ever made came off the line with a 28 spline 9" in the back. Several versions of that 9" over the years, but still every one is a 28 spline version.

Now what has happened in the 50 years or so since they were built, can't say. IF the Bronco was built up in the past with some good parts, 31s may have been swapped. But a regular Bronco that is just driven around, probably not. Unless you know the history you never know until it is opened up.

Although completely possible, I have never seen anyone do a 31 spline with an open diff.
 

Rustytruck

Bronco Guru
Joined
Feb 24, 2002
Messages
10,872
Just to cover the bases stock dana 44 axles in the front axle are 30 spline in the differential.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
Just to cover the bases stock dana 44 axles in the front axle are 30 spline in the differential.

And the Dana 30 was 27-spline. Not that it should matter since there are plenty of weak parts in a 30 before the shaft/spline size is an issue.
 
Top