68ford
Bronco Guru
- Joined
- Dec 26, 2004
- Messages
- 2,710
I've seen setups similar to what you describe. What about doing the same thing from the valve cover at the rear on one side, have the oil filler on the opposite front side?
I currently run breathers in both, the problem is the breather is at an angle so there will always be some residue that leaks out the bottom side of the breather below the tube opening. If you had a tube that went into the valve cover and then angled to where the breather sat straight up would help with that. Haven't found such an animal but could be made i guess.
I just recently pulled my 395 that was built in 2005, I didn't run a PCV but it had started smoking under hard throttle, still ran great. I decided to build a new roller motor. When tearing down the 395 there was basically no wear in the cylinders, however when I took the heads (Edlebrock RPM Performer) to the machine shop for rework to go on the new engine it was found that every intake valve and guide was bad. These heads were bought new and bolted on, machine shop said the guides and the seats on the intake valves were out of alignment and is why they had worn so bad. I kept one of the valves and have it on my desk as a reminder to not just bolt on new parts without checking them out. That's where my oil was coming from. Nothing else I saw on this engine over 15 years not running a PCV concerned me.
You can run a hose from anywhere up to the air filter base. Just make sure there is enough hose that you can remove your air filter base without having to remove the hose if you care. Also try to not have any low points in the hose for oil to collect.











