Had nothing but problems with Fitech. Finally found a guy who was able to tune it. Runs well now but I'd never do it again or recommend it to anyone. Same guy says Sniper much easier to tune if you know how.
Sent from my iPhone using Tapatalk Pro
If you think electronics on the throttle body is bad, many OEMs have been putting transmission computers (the actual computer, not just the solenoids) inside the transmission valve body. Been doing that for decades.
Check the height of the ProFlo intake manifold on line. I think it uses the SuperVic like I do and it is quite a bit higher than an Edelbrock Performer intake... like an inch or so?? Do the math- its easy.
Go on line, take the two measurements you need and make sure it will clear.
I run the Pro-Flow 4 on my 331 stroker. As was mentioned about a 1 inch body lift is necessary and the time consuming part was the wiring and the fuel system mods were the time consuming part. It runs awesome, my only complaint is the somewhat limited tuning parameters. I would like more tuning ability in the cold start and high idle speed while cold. My initial startup was easy and it is much simpler to tune that my LS1/Holley system was but not nearly as many parameters to tune. I'm very happy over all with the Pro-Flo 4.Regarding heat soak with Fitech. Cured it with a 1” composite spacer. Just barely had room. But it worked.
Sent from my iPhone using Tapatalk Pro
What are you using for an air cleaner? I have a 331 w/ 1" body lift also and am hitting the distributor with my 14" round drop base w/ 3" filter elementI run the Pro-Flow 4 on my 331 stroker. As was mentioned about a 1 inch body lift is necessary and the time consuming part was the wiring and the fuel system mods were the time consuming part. It runs awesome, my only complaint is the somewhat limited tuning parameters. I would like more tuning ability in the cold start and high idle speed while cold. My initial startup was easy and it is much simpler to tune that my LS1/Holley system was but not nearly as many parameters to tune. I'm very happy over all with the Pro-Flo 4.
It is a small, Summit Racing, small chrome filter that is about maybe 2" tall. There isn't much room as you well know. I don't recall the part number off hand. My Bronco is in storage right now but I could get you more info when I get it out.What are you using for an air cleaner? I have a 331 w/ 1" body lift also and am hitting the distributor with my 14" round drop base w/ 3" filter element
Too ugly-And how much is Ford SEFI system over these aftermarket kits that have gremlins?
-I just don't get it, Ford perfected EFI. Yes it is ugly but works, is reliable, and parts can be had at almost all parts places.






