• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Question on Petronix 2 upgrade

fluffybunny

Full Member
Joined
Oct 28, 2015
Messages
219
Just my opinion here but to run ethanol free getting 8-9mpg is a waste of money. The gas isn't in there long enough for phase separation to set in and with all the work you've done I'm gonna say your soft lines are ethanol resistant. I have noticed that the E free fuel will act like it's flooded/vapor locked when trying to start after it's hot.
My reason for using ethanol free is I'm still doing a lot of work on mine and it's not getting much street time yet. I've only clocked about 120 miles since putting in a rebuilt motor last spring so I don't want the gas to go bad.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Don’t eworry about gas mileage in a brand new engine. It’s not ready for prime time yet
It might not be the same once it gets 1000 miles or two on it.
Also, usually still some fine-tuning to be done.
 
OP
OP
salineriverman

salineriverman

Jr. Member
Joined
Dec 29, 2021
Messages
54
Loc.
Wilmar
Don’t eworry about gas mileage in a brand new engine. It’s not ready for prime time yet
It might not be the same once it gets 1000 miles or two on it.
Also, usually still some fine-tuning to be done.
Finally got petronix 2 installed with new coil and relay. Was not getting enough fuel so we installed an electric fuel pump and filter in line after tank selector valve. Seems to be getting plenty of fuel but headers glowing red. Distributor was froze up and after much tapping and PB blaster were able to adjust timing! Running great !! Got home and took gas caps off and added fuel . System seemed to lose its vacuum - went to running rough and died. Took a while to get it back running off front tank. Will not run off new rear tank since it ran out of gas a week ago. Both tanks have new ascending units but haven't gotten fuel gauges working yet. Thinking tank vents not working ?? Old lines to canisters are bent and folded back. Any ideas. The timing adjustment and carb adjustment solved the sputtering and red hot header issue . Until I took gas cap off!!!
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Was not getting enough fuel so we installed an electric fuel pump and filter in line after tank selector valve.
Can help, but what led you to believe you were not getting enough fuel?

Seems to be getting plenty of fuel but headers glowing red. Distributor was froze up and after much tapping and PB blaster were able to adjust timing! Running great !! Got home and took gas caps off and added fuel . System seemed to lose its vacuum - went to running rough and died.
Nothing is supposed to be held in the tanks. Not vacuum, not pressure.
Whenever this happens (inrush or outrush of air) when you take the cap off, something is amiss.
But why it would run good with the caps and not without is a definite mystery! Most with a venting issue run better when the caps are removed.

Will not run off new rear tank since it ran out of gas a week ago. Both tanks have new ascending units but haven't gotten fuel gauges working yet. Thinking tank vents not working ??
Sounds like it, but once you remove the caps there should be no restriction to breathing.

Old lines to canisters are bent and folded back. Any ideas.
Sure... Fix or replace them!
Where are they bent/crimped?

The timing adjustment and carb adjustment solved the sputtering and red hot header issue . Until I took gas cap off!!!
Great news on it running better with the Pertronix and correct timing.
NOT good news about the caps off making it run weird!

As a refresher (or in case you have not already discussed it here) what rear tank did you install, and did it ever run off the new tank?

Paul
 
OP
OP
salineriverman

salineriverman

Jr. Member
Joined
Dec 29, 2021
Messages
54
Loc.
Wilmar
Can help, but what led you to believe you were not getting enough fuel

Watching fuel filter was almost always empty and not pumping hardly any gas .

Nothing is supposed to be held in the tanks. Not vacuum, not pressure.
Whenever this happens (inrush or outrush of air) when you take the cap off, something is amiss.
But why it would run good with the caps and not without is a definite mystery! Most with a venting issue run better when the caps are removed.


Sounds like it, but once you remove the caps there should be no restriction to breathing.


Sure... Fix or replace them!
Where are they bent/crimped?
Old canister is gone line is bent and folded back towards frame.
Great news on it running better with the Pertronix and correct timing.
NOT good news about the caps off making it run weird!

As a refresher (or in case you have not already discussed it here) what rear tank did you install, and did it ever run off the new tank?

Paul
I installed a new rear steel tank kit from Tom's - took aux. Tank off and had it cleaned , new filler and vent hoses and ascending units. Ran new gas line , installed new tank selector valve. New fuel pump - actually on second one of those - when rear tank went dry I thought pump went out because wouldn't pump fuel. Put second pump on but still wouldnt pump so added fuel to both tanks . Rear tank worked for a bit but wanted to try front tank and switched to it. Had to disconnect rubber lines and blow thru them to get flow going. Been running off front tank - tried to swap back to rear and when fuel ran out engine did usual sputtering and quit. Tried to switch back to front but no flow. Had to take line loose at filter before carb and hooked back up and went to pumping. Noticed some trash in filter at carb. Plan on replacing .
Also since adding electric pump to assist manual pump fuel filter seems to keep more fuel in it.
After it quit yesterday evening I was under hood and heard funny noise took breather off carb and like steam or vacuum coming from carb. I had been trying to crank it and had it choked not sure if this causes it. I let it set for couple hours - said a prayer and went out and it cranked wasn't running good but able to get it under barn. Put battery charger on it and finally got it to crank and running off front tank. Was really hard to crank sputtering and backfiring again. Ran for 10 minutes or so and stopped backfiring . Had to go to Louisiana with wife so didn't fool with it any today.!
Not sure why tanks won't switch back ,
Any suggestions are appreciated - it ran like a new one yesterday until I decide to pour some gas in tank. Using premium ethanol free gas.
 
OP
OP
salineriverman

salineriverman

Jr. Member
Joined
Dec 29, 2021
Messages
54
Loc.
Wilmar
Old canister is gone line is bent and folded back towards frame.

I installed a new rear steel tank kit from Tom's - took aux. Tank off and had it cleaned , new filler and vent hoses and ascending units. Ran new gas line , installed new tank selector valve. New fuel pump - actually on second one of those - when rear tank went dry I thought pump went out because wouldn't pump fuel. Put second pump on but still wouldnt pump so added fuel to both tanks . Rear tank worked for a bit but wanted to try front tank and switched to it. Had to disconnect rubber lines and blow thru them to get flow going. Been running off front tank - tried to swap back to rear and when fuel ran out engine did usual sputtering and quit. Tried to switch back to front but no flow. Had to take line loose at filter before carb and hooked back up and went to pumping. Noticed some trash in filter at carb. Plan on replacing .
Also since adding electric pump to assist manual pump fuel filter seems to keep more fuel in it.
After it quit yesterday evening I was under hood and heard funny noise took breather off carb and like steam or vacuum coming from carb. I had been trying to crank it and had it choked not sure if this causes it. I let it set for couple hours - said a prayer and went out and it cranked wasn't running good but able to get it under barn. Put battery charger on it and finally got it to crank and running off front tank. Was really hard to crank sputtering and backfiring again. Ran for 10 minutes or so and stopped backfiring . Had to go to Louisiana with wife so didn't fool with it any today.!
Not sure why tanks won't switch back ,
Any suggestions are appreciated - it ran like a new one yesterday until I decide to pour some gas in tank. Using premium ethanol free gas.
Paul , as to answer your question on why we thought it wasn't getting enough gas ? We were watching the fuel in the filter when trying to crank and it taking a while to pump fuel to carb. The gas had been draining back to the tank. Seems like with the electric fuel pump the filter is not draining back to the tank as bad as it was previously. This could have been some of the original issue with taking so long to crank prior to the Petronix kit.
 
OP
OP
salineriverman

salineriverman

Jr. Member
Joined
Dec 29, 2021
Messages
54
Loc.
Wilmar
did you check the tank for debris in it before install?? having junk in new tanks has been a big issue over the years. just a thought...
I inspected the tank before dropping it off with my mechanic who did the installation. It's possible some fine debris was in tank and we overlooked it.
May need to drop tank and clean it !!
 

m_m70

Contributor
Bronco Guru
Joined
Jun 14, 2001
Messages
1,770
Loc.
Prescott AZ
installed new tank selector valve
was the original bad?? If not, switch back and see what happens.

New fuel pump - actually on second one of those
have you checked for flow by disconnecting the line at carb and trying to start with fuel line into can?? disconnect coil so motor doesn't fire with gas in the bowls.
Safer way is to just get a fuel pressure gauge. Edelbrock's like around 5 psi

Noticed some trash in filter at carb
this can be an issue if some trash got into carb

Also since adding electric pump to assist manual pump fuel filter seems to keep more fuel in it.
After it quit yesterday evening I was under hood and heard funny noise took breather off carb and like steam or vacuum coming from carb.
assuming this is a low pressure pump. do you know how much pressure is at the carb with this?
I wouldn't run an electric after the diaphragm. If your original pump cant get enough fuel to the carb, it's not going to get enough to the electric pump.

Why not just run the electric only with a regulator?

it ran like a new one yesterday until I decide to pour some gas in tank
how much gas did you add?? should have at least a few gallons in each tank to make sure the sending unit can pick up and not sucking air.

bad gas maybe??
 
OP
OP
salineriverman

salineriverman

Jr. Member
Joined
Dec 29, 2021
Messages
54
Loc.
Wilmar
was the original bad?? If not, switch back and see what happens.

Original tank had a hole in it.
Original tank had a hole in it.
have you checked for flow by disconnecting the line at carb and trying to start with fuel line into can?? disconnect coil so motor doesn't fire with gas in the bowls.
Safer way is to just get a fuel pressure gauge. Edelbrock's like around 5 psi

We've disconnected lines and blower through them to get flow going - also ran a different gas line for a bit but then went back to original lines - I do have a pressure gauge and will try and check today.

this can be an issue if some trash got into carb


assuming this is a low pressure pump. do you know how much pressure is at the carb with this?
I wouldn't run an electric after the diaphragm. If your original pump cant get enough fuel to the carb, it's not going to get enough to the electric pump.

Why not just run the electric only with a regulator?


how much gas did you add?? should have at least a few gallons in each tank to make sure the sending unit can pick up and not sucking air.

bad gas maybe??
I added 4 gallons to rear tank - front tank seemed full - gas spewing back out.
We installed the electric pump in the line before it gets to the manual pump.
Thanks for your suggestions.
 
OP
OP
salineriverman

salineriverman

Jr. Member
Joined
Dec 29, 2021
Messages
54
Loc.
Wilmar
The o
Original tank had a hole in it.



I added 4 gallons to rear tank - front tank seemed full - gas spewing back out.
We installed the electric pump in the line before it gets to the manual pump.
Thanks for your suggestions.
The original switch was frozen up and trash-
I took gas line loose at electric pump and had gas - then took loose at filter before carb - pumped some gas into jar - it had some fine particles that looked like rust and little slivers of fuel line - like my fuel line which is new is coming apart. I went back to Oreilly’s and questioned them on their line which I paid $6 a foot why it was coming apart. They originally assured me when purchasing it would work fine !! Today he said it could be coming apart more designed for PVC lines than carb fuel lines. So guess I’ll be replacing them .
Bought some new line from Bumper to Bumper for around $2.75 a foot. Hope this helps ! Plan on running off front tank and see if issues go away. Also plan on checking pressure before carb.
Thanks for all of the advice.
 
Top