MerganserMaster
Jr. Member
- Joined
- Jun 9, 2023
- Messages
- 115
The idle on my 1975 Ford Bronco does not seem to want to go below 990 RPM, and I cannot seem to figure out why. For context, it is a '75 302 with a manual RAT transmission. The carburetor is a motorcraft 2100 (i believe) and no matter what I do the idle does not want to drop.
To set it up I first set the timing to about 10 degrees BTC (at engine operating temp), then I screwed in both fuel/air mixture screws all the way in and back out 1.5 times. After adjusting them so that I had 18 inch-lbs of vacuum (with no rise in RPM gained by moving them outwards) and turning the timing so that it was a few degrees closer to zero (~7 or 8 BTC) I got ~750 RPM and then I turned the engine off and put the air cleaner assembly and the vacuum line back on the distributor (which I had my gauge hooked up to). However, after starting the engine again and checking the RPM again, it read 1100 RPM and no matter what I have done since, it does not seem like it wants to go down again. I've checked for leaks around the carburetor gasket with carb fluid and have found none yet. I have the choke set open and the only vacuum line attached to it (running to the distributor) is free from cracks/damage (to my knowledge). The carburetor was rebuilt a couple of years ago and it hasn't been run that much (1000 miles at maximum). It does not appear that there is a "fast idle" screw wither on my carb that might be interfering with its operation.
My questions are:
What might be causing the RPM to be so high?
Is my timing messed up?
Do I need a new/different carburetor setup?
Below are a couple of photos of my carb:
https://flic.kr/p/2rci4yJ
https://flic.kr/p/2rchcfV
To set it up I first set the timing to about 10 degrees BTC (at engine operating temp), then I screwed in both fuel/air mixture screws all the way in and back out 1.5 times. After adjusting them so that I had 18 inch-lbs of vacuum (with no rise in RPM gained by moving them outwards) and turning the timing so that it was a few degrees closer to zero (~7 or 8 BTC) I got ~750 RPM and then I turned the engine off and put the air cleaner assembly and the vacuum line back on the distributor (which I had my gauge hooked up to). However, after starting the engine again and checking the RPM again, it read 1100 RPM and no matter what I have done since, it does not seem like it wants to go down again. I've checked for leaks around the carburetor gasket with carb fluid and have found none yet. I have the choke set open and the only vacuum line attached to it (running to the distributor) is free from cracks/damage (to my knowledge). The carburetor was rebuilt a couple of years ago and it hasn't been run that much (1000 miles at maximum). It does not appear that there is a "fast idle" screw wither on my carb that might be interfering with its operation.
My questions are:
What might be causing the RPM to be so high?
Is my timing messed up?
Do I need a new/different carburetor setup?
Below are a couple of photos of my carb:
https://flic.kr/p/2rci4yJ
https://flic.kr/p/2rchcfV











