Not directly relevant to OPs post, but I thought the Bronco factory wiring was done such that the if the factory starter solenoid is getting power at the S terminal, it cross feeds a full 12 volts to ignition coil (via the I terminal on solenoid) when key is in start position?
Yes, exactly right.
The small Brown "I" wire is hot when the key is in the ON position, but it doesn't do anything to the starter relay because that stud is isolated until power gets to the "S" wire and that closes the internal contacts.
Because the Brown wire gets power from the key, that aspect of the ignition switch can be checked by probing the Brown wire with a volt-meter.
Or, in liu of a volt-meter, you can remove the Red w/blue "S" wire and swap the Brown "I" wire over to that S terminal. Make sure it's in Park or Neutral however, because as soon as you turn the key to ON, the starter will crank!
If it doesn't, then you have an ignition switch or wiring issue.
A simple test is pull the wire off S terminal and see if it has power when key is turned to start. That would rule out all switch, nss, etc very fast.
Also correct. Testing the starter relay is relatively easy most of the time.
First, for the OP, now that you've jumpered the two large posts and determined that the starter, battery and battery cables are all working, do the next test.
Remove the Red w/blue stripe wire from the "S" post and jumper from the hot battery side to the small post/terminal. IF the starter cranks, then you've proven that the starter relay is still good and you have an issue upstream.
If it does not work, then the relay is bad.
Somebody knows more about this then me, but does OP have a geared starter? Doesn’t that require some wiring mods?
Good question. It does require a little bit of a wiring change usually, but should not preclude the initial testing of the starter relay, the neutral-safety swtich (if present), the neutral-safety and backup light switch connector with bypass wire, and ignition switch.
But it's certainly next on the list!
Paul