Search results

Was it from corrosion or electrolysis? Aluminum is prone to electrolysis. If you do not keep fresh coolant with the correct PH the aluminum will be the sacrificial anode. It is a good idea to use the WH electrolysis protection radiator cap and change the coolant/distilled water mixture often...

My 67 with 289 and stock radiator would run at around 180-185 most of the time and would get up around 200-205 if I was making alot of red light stop and go. If I parked when hot it would get even hotter 210+ and take at least one minute of driving to come back down. Ordered a Ron Davis...

Bronco Gray...but close enough

Bump Bump to top

Bump Bump to top

Bump Bump to top

Skis I like em". I was gonna build something like one of these below but went with the Hansons. I like the larger tubing on these below. I like square tubing for rocker and round for nerf.

Wiring Wiring is a pain. It is time consuming and sometimes best ledt to a pro. On the below dash I cut the holes and set up the dash and made harnesses for each gauge using weather pak 4 prong connectors (light power,light ground, gauge power, gauge ground) the sender was the final wire for...

Interior Procar Rallye Tuffy security console Herculiner Custom Dash On board air in rear box 1967

Boss 302 I did some research with a friend who has 2 Boss 302's one with the hood stripe and one with the full blackout option. The hood paint is not available in the exact code as the factory did but PPG copied it, the one I listed above is the correct code. It was a textured low gloss.

I am going to get a new hood but will probably not to a repaint until next year. I was thinking of just going with the blackout hood like on a Boss302. Paint is PPG Textured low gloss black PPG/Ditzler DDC 9381 HP Black. Anyone done this and have a picture?

Key Just went through that.... Use a screwdriver to move the switch to the righ ttposition. The key barrell point is not flat...the end is tapered. Be sure you are lining it up. Put it in...push in with the paperclip and then turn back until it clicks in.

Protofab Protofab. I may shorten the height of the push bar and repaint it. I think it is too tall. I would have them cut it down a little before they ship it to you.

http://www.transmissioncenter.net/speedometer_calibration_______va.htm?gclid=CMCvwKm3opYCFQENgQodRBvL6g

Deck location Tuffy stereo center console is where the deck goes.

Dash Dash shots just finished mine

Bronco & TV I think that was the same Bronco that was at the beach in the last Knight Rider episode

12 fuse accessory panel. without fuses. Marine grade. Costs $58 at West Marine Has 12 positive posts and 12 ground posts. 120 amp max Has cover to protect fuses and blank stick on labels. I used one of these for a very clean install of all my autometer gauges, interior light, air...

I have some dash parts left over. 3 knobs-2 new 1 old but clean 2 bezel nuts-new fan bezel-new wiper washer bezel-new ignition bezel-old but good bezel nut tool-new best offers including shipping

I needed 1 1/2" convoluted tubing to finish off my dash and wiring install. I had to buy a 50 foot piece and only needed 12 feet. If you need 1 1/2" tubing I will sell it by the foot for what I paid including shipping.