Search results

Why go through all that, when Edelbrock makes the Pro-Flow 4? real fuel injection (not a crap sniper on Fitec) Bolt on intake and go..... I installed Pro-flow in less than 12 hours....

up to 22.7 ...

Mount your phone so it can take a movie of the pinion and drive down the road. accelerate normally and brake too. Do this a few times and You'll see the yoke possibly shoot up. (mount the phone securely)

It was $2200.00 out the door for the kit, included intake Dizzy, ECU and complete harness, gaskets, fuel lines....

I'm getting 22.5mpg with BB and I4

"Milking it for mileage" is what I did not do, picked it up with 16 miles on it and headed down the Mass Pike for a hour at a steady 95 mph (day one) Jack rabbit starts, @ 10 mph over posted speed constantly, Stop and go- Sport mode, ect, it started at 17 mpg, after 1000 miles, it's up to 22.4...

Coverage is specified by the cement cracking crumbling, but since the doors shifted and twisted a little, new doors are not part of the "coverage" and the sill that is rotted with water impingement means wall replacement (not covered) .....BUT complete demo of structure IS covered, but new...

After over 600 days of waiting, and getting it July7, Two-weeks later the proposals are coming in (after waiting 4 years for approval) for the replacement of the crumbling foundation on the garage. The funding covers the new foundation and floor, but not the structural damage caused BY the...

Mine was built 6.20. Delivered 7.5.22

I don't know if it's the same in the 4-door, but on my 2-door If you want to use the rear aux wire harness, which is "E" in the manual, It is unlike the one that goes to the grille, the grille wire starts at the fuse block, so you can tap into whichever AUX switch you want, and the other end...

I ended up using AUX switch #6, wired to white wire that leads to behind the glove box. Attached a female socket and plugged in camera socket..... Johnny Rebel did ya notice the small sliding tray cannot slide to the rear (in the groove) because the lighter socket cover is about and 1/8" too...

Was going to set up a dashcam, and it came with the typical "lighter" plug-in, but there's no socket up front (on Big Bend) Any suggestions? (without cutting the new dash cam's wire).

make a heat shield between head and plug wire

Ill be starting my Mods soon, first off...the BB stickers...got plans...

my BB was delivered yesterday, (6.20.22 build) is "dirt Mountain" Gone?

nothing new here "nothing to see here" go Home..... Guess Ford's word on "scheduled Production date" is just as good as "reservations"

Thanks Rany, Checked today, web site updated to "'in production" "window sticker is now available"

Hi Randy, When was the "scheduled build date" just checking the timeline