Braddw25
Full Member
So I'm getting ready to swap a 250 inline into my Bronco instead of the 170 that's there. Has anyone here actually performed this swap? I'm particularly interested in what if anything you did to the stock motor mounts. I understand that the 250 is a little over an inch wider on the bottom end compared to the 170. I read on the FOrdsix site that this will cause the 250 to sit higher in the engine bay than a 170 or 200 would. Since the 250 is already taller than those blocks, I'm thinking this could cause me some problems. Also, would it cause problems with getting the rest of the driveline to line up right if the motor is sitting a bit higher than it should. Much of the info on the fordsix sight is based on Mavericks, Falcons, and Mustangs, so I'm not sure if the problems described there apply to the Bronco as well. That is why I would like to hear from someone who has actually done this swap.
I do know that I will have to either do a body lift or use some sort of hood scoop, and that the oil pan will need to be changed to rear sump. Any other issues that I should be aware of with this swap??
Thanks!
I do know that I will have to either do a body lift or use some sort of hood scoop, and that the oil pan will need to be changed to rear sump. Any other issues that I should be aware of with this swap??
Thanks!











