Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
If you have problems registering or can't log into your account, please contact Admin.
While I have our 71 302's motor torn apart for a 4bbl intake and carb I would like to put in a little bit bigger cam. What is a good streetable cam for a stock motor that you folks have had good luck with. It has a manual trans.
If the engine is still in the bronco you cant change the cam without either removing the grill or Cutting a hole in the grill. That said a lot of people use the edelbrock performer cam with good results. I run a crane cam with similar specs to the performer cam.
I was able to change the cam in my Bronco without removing or cutting a hole in the grill. Didn't pull the motor either. It was done about 12 years ago, so I don't remember how difficult it was, but don't recall any problems.
I think the only broncos with V8's that you might be able to swap the cam in with no problem would be a v8 conversion that wasnt done correctly. Last cam swap I did in the vehicle I needed to loosen one side of the grill to get that extra needed clearance.
Just take off the front of the grill. I had the same issue a while back and was glead I decided to take off the front instead of cutting anything. It was easy.