Anyone regret going to twin sticks on J shifter?

[Skiddy]

You can also check the FAQ section.

 

[tasker]

There is nothing like twins! %)

 

[Madgyver]

You can build your own if you know how to weld...................
Bend it to your liking........

 

[ugly74]

I got an improved design single J stick from James Duff, and I'm perfectly content with it. it goes into 4 hi or low much easier than the original, and pops back out just as easy. sometimes I hafta back up just a hair to get out of 4. but I don't do a lot of hardcore wheelin, where you may really need front wheel low%)

 

[kntr]

what do you mean by options?

I mean 4wd, 4lo, rear 2wd, rear 2lo, and what else.

 

[Tito]

4wd hi
4wd lo
fwd hi
fwd lo
rwd hi
rwd lo
and
neutral

 

[buknbronco]

twin sticks all the way.

 

[scottz]

What about with a T shifter? Same advice?

 

[broncotime]

4wd hi
4wd lo
fwd hi
fwd lo
rwd hi
rwd lo
and
neutral

You forgot these two possible (but ugly) scenarios:
fwd hi/rwd lo
fwd lo/rwd hi

Never tried it, but I'm sure someone out there has.

 

[jarrod]

No complaints!!

 

[Mtn Gote]

Twin Stick

What about with a T shifter? Same advice?

Yes what about the T shift. I too want to know.

 

[Project_bronco]

twin sticks all the way.

Congratulations on the new arrivals. lol
Break out the cigars.

 

[Project_bronco]

OH, that's kind of embarrasing. I thought you said, "twin sticks on the way" like you ordered them. Oh well. %)

 

[va bronco]

You forgot these two possible (but ugly) scenarios:
fwd hi/rwd lo
fwd lo/rwd hi


That's a good way to destroy a T-case.

 

[burntfish]

Does anyone have the instructions for the install on the twin. I got a used one and need some info on the install. Sorry for the hijack. I've also have the 20 it was on with a blown tail on it. Thanks in advance for any help.

 

[kntr]

4wd hi
4wd lo
fwd hi
fwd lo
rwd hi
rwd lo
and
neutral

Are these possible with the install of a twin stick kit or do you have to do any mods to the shifter or Tcase?

 

[Tito]

With the J-shift install, these are all possible with just the typical install but the t-shift requires some internal mods. Don't think they are real involved but there is some internal modification required. I actually need to find out what I need to do to mod my hlafcab t-shift.

 

[Mtn Gote]

Twin Stick

Me To, Me To.

 

[Skiddy]

Me To, Me To.

Here is a good write up on the T-shift twin stick http://www.wt4x4.net/tech/twinstick.htm

 

[crewdg]

I have the J Fab sticks for a J-shifter and was able to shift from Hi to Low on a hill during OCBR at Hot Springs. This would have been impossible with my old J-shifter. haven't had any problems with them popping out either. The worse thing was cutting off the flags with the case installed using a recip saw. I went through some blades! Couldn't get the right angle with a grinder and cutting wheel. My sticks are new, but so far no regrets!