• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Bearing puller

turbotim2

Contributor
____________
Joined
Jun 26, 2003
Messages
2,158
Can anyone recommend a good but inexpensive bearing puller to remove a manual transmission pilot bearing from a crankshaft?
 

kat

Bronco Guru
Joined
Jul 22, 2015
Messages
1,057
Loc.
Bristol
A couple screwdrivers might work. Or you can rent one from Auto Zone Etc.
 

Rustytruck

Bronco Guru
Joined
Feb 24, 2002
Messages
10,872
supposed to fill the hole with grease and drive in a shaft that is tight to the hole and drive it in pushing the bushing out. never worked for me, as bushings i used a saw to cut most of the way through and then pry them out. some people tap them and then use a bolt and washer with an oversize socket and screw the bolt in pulling the bushing out. just depends what you have to work with. pilot roller bearings are much tougher to deal with.
 
OP
OP
T

turbotim2

Contributor
____________
Joined
Jun 26, 2003
Messages
2,158
I have tried the bolt idea and it just slips off. The bearing cage is also partially gone from the screwdriver idea. Our parts stores don't carry anything like that either...
 

Cooper

Full Member
Joined
May 7, 2006
Messages
309
Loc.
Northeast
"Garage Squad" performed the method Rusty Truck describes above but used white bread. Just Google "removing a pilot bearing with bread." Watching it being done on You-tube is much easier than wrapping words around it here; it is simple, cheap and much less messier than grease.
 

SteveL

Huge chevy guy
Joined
Jun 24, 2001
Messages
11,969
Loc.
Hawthorne ca
Where are you located? Somebody here may have a puller you could borrow. About one fairy cheap thru summit. Never had any luck with the grease method.
 

JSBX

Contributor
Sr. Member
Joined
Mar 10, 2010
Messages
652
The bread trick worked a couple times for me.
 

Jdgephar

Bronco Guru
Joined
Sep 25, 2012
Messages
1,526
I think I used wet newspaper instead of bread last time i had to remove one.

Sent from my SM-G981U using Tapatalk
 
OP
OP
T

turbotim2

Contributor
____________
Joined
Jun 26, 2003
Messages
2,158
Well the bread trick didn't work for me. I got it out by other means though.
 

ngsd

Contributor
Bronco Guru
Joined
Mar 2, 2019
Messages
2,702
I bought a bearing puller and it would not budge with a big ass slide hammer. I never tough the grease trick would do it if the slide hammer failed but I was totally amazed that it worked easily. I used a brass punch that was snug, filled the hole with bearing grease tightly and it popped right out. I guess when you think about it, hydraulics are more powerful than hammers and physics rule but still was skeptical.
 
Top