• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Blown Head Gasket?

B RON CO

Contributor
Bronco Guru
Joined
Jun 29, 2016
Messages
2,484
Loc.
Statesville, NC
Hi, do you think all the bolts were properly torqued?
You should double check the torque on the other side.
Good luck
 
OP
OP
Smedley

Smedley

Sr. Member
Joined
Feb 28, 2004
Messages
928
Loc.
Snohomish
It was a reman engine. I had about 15 to 20k on it prior to starting the rebuild. No issues that I knew of when it was running.

Will

Hi, do you think all the bolts were properly torqued?
You should double check the torque on the other side.
Good luck
 

Rustytruck

Bronco Guru
Joined
Feb 24, 2002
Messages
10,872
Clean out all the bolt holes and put the head back on with out the head gaskit and make sure the head bolts go all the way down and clamp the head. Then you will be sure when you put the head on with a gasket it will properly torque down. Looks to me number 3 cylinder head gaskit was leaking. I always used Felpro printo seal head gaskits.
 
OP
OP
Smedley

Smedley

Sr. Member
Joined
Feb 28, 2004
Messages
928
Loc.
Snohomish
Well. I got lots of advice. Two school of thought, replace both or fixed what is broken. I opted for the latter. Replaced the bad side head gasket. I did a compression test and got ~120 on all cylinders. Got it all put back together and fired it up. So far so good. Did not drive it, just had in running in the driveway for a while. No leaks, engine sounded smooth. Time will tell.

Thanks for all of the input.

Will
 
Last edited:

Timmy390

Contributor
Bronco Guru
Joined
Jan 1, 2011
Messages
5,948
Loc.
Conway, AR
Glad to see this worked out well. Simple gasket change and back on the road is good news.

Tim
 
OP
OP
Smedley

Smedley

Sr. Member
Joined
Feb 28, 2004
Messages
928
Loc.
Snohomish
Nah now you are an expert! Do the other side as therapy! Great news you got it fixed.

Mark. I did as you recommended. Only swapped the bad gasket and used the old bolts. All of the intake gaskets were new, so I reused them. $25 and weekend. I also flushed the coolant system to get all of the mud and gunk out.
 
Top