• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Body flex

bamabaja

Contributor
Sr. Member
Joined
Mar 25, 2012
Messages
729
Loc.
The Shoals
Yesterday took Offroad build on first test drive. Previously started numerous times and moved in garage. So after 2 blocks on paved street, fan into new aluminum radiator. Had 1 1/2” fan to radiator clearance. So quickly checked usual culprits, motor mounts, trans shifting forward, fan clutch. No obvious problems. I do not have bump stops or limit straps. Could body flex be problem ? But on paved road ? Any ideas or suggestions appreciated. After 4 year build kinda bummed out. Thanks
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Check the front body mounts. I had some torn away from the body. Rubber and bolts were good, but the body not atached to the body mount tab. Grill shifted sideways and that caused fan into shroud which deflected into the radiator.
 

blubuckaroo

Grease Monkey
Joined
Jun 11, 2007
Messages
11,796
Loc.
Ridgefield WA
My fan ate the radiator once. I had about an inch clearance.
I was doing a "crowd pleaser" and missed third gear. Dam that thing comes up quick!:eek:
I know the motor mounts were good. I put a jack under the bell housing and picked the front of the car off the ground.
 

Attachments

  • IMG_20170722_150628440_HDR.jpg
    IMG_20170722_150628440_HDR.jpg
    95.2 KB · Views: 126

jckkys

Contributor
Bronco Guru
Joined
Mar 15, 2012
Messages
5,221
What specific ie. make and part number fan was involved not just the category such a flex or fixed blade. Something had to bend or flex far too much.
 

blubuckaroo

Grease Monkey
Joined
Jun 11, 2007
Messages
11,796
Loc.
Ridgefield WA
OP
OP
bamabaja

bamabaja

Contributor
Sr. Member
Joined
Mar 25, 2012
Messages
729
Loc.
The Shoals
I found the problem: ME. Briefly, I got HD off road aluminum radiator, and fab’ed into radiator core support. Rad width would not allow use of hood latch parts, so removed and installed hood pins. BUT, it seems I failed to allow for bracing function of the hood latch parts, and did not adequately brace in this body area. Therefore, at sufficient RPM, fanflex and Highway stress… Scrap aluminum. But learning experience, as were all prior dumbass mistakes. And hope around for many more ! Stay well !
 
Top