Bukin 67
Bronco Abuser
- Joined
- Jul 3, 2008
- Messages
- 2,268
My situation requires stopping power for close to 5000 # of Bronco momentum racing on dirt, and since I'm only running 15" wheels, that has to be done with a smaller rotor.
My current system includes 4 disc Wilwood master with 1-1/8" bore, 4 piston Wilwood caliper rear and 2 piston D52 Wilwood front with 2" pistons. (I already plan on replacing the 2 piston front with a 4).
I have all new lines with a proportioning valve mounted on the firewall about 24" or less from the master.
I'm using a typical aftermarket Bronco vacuum booster combined with a 100% duty cycle electric vacuum backup in case of engine failure. It's always on and only kicks off when the vacuum cylinder is evacuated. I've also replaced the main booster with no change.
This system just won't lock em up on the pavement. Maybe a have a gremlin I don't know about?
I know hydroboost is an option, but I think I'll be taxing the explorer p/s pump too much since I already have the ram assist steering on it.
Anyone gone electric? I'm gravitating toward that, since a hot rod builder buddy of mine has good luck with them, and they'll put out 1300 lbs. or better.
My current system includes 4 disc Wilwood master with 1-1/8" bore, 4 piston Wilwood caliper rear and 2 piston D52 Wilwood front with 2" pistons. (I already plan on replacing the 2 piston front with a 4).
I have all new lines with a proportioning valve mounted on the firewall about 24" or less from the master.
I'm using a typical aftermarket Bronco vacuum booster combined with a 100% duty cycle electric vacuum backup in case of engine failure. It's always on and only kicks off when the vacuum cylinder is evacuated. I've also replaced the main booster with no change.
This system just won't lock em up on the pavement. Maybe a have a gremlin I don't know about?
I know hydroboost is an option, but I think I'll be taxing the explorer p/s pump too much since I already have the ram assist steering on it.
Anyone gone electric? I'm gravitating toward that, since a hot rod builder buddy of mine has good luck with them, and they'll put out 1300 lbs. or better.











