• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

C4 End Play

Torkman66

Contributor
Sr. Member
Joined
Apr 3, 2022
Messages
854
Loc.
New Braunfels, Tx
Finished rebuilding the C4 today. Everything went well. However, before the rebuild endplay was .004 and after rebuild endplay is still .004. Normal range is .008 to .042. I even removed the #2 thrust washer on the end of the pump to see if that made a difference and endplay remains .004 which makes no sense. The #2 washer is supposed to determine the endplay...removing it the endplay should be huge (it is .075 think.) How could the pump shaft be bottoming out with no #2 washer installed? Even with .004 end play I can move the shaft by hand with no problem.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Are you measuring at the input while forcing the shell and rear planet carrier apart with a screwdriver or something similar? Sure you have the correct thrust washers in the correct places? There are 2 different ones that could go on top of the rear planet depending on which planet you have. Washer kits typically include both. The wider one could force everything forward on the wrong carrier. Also make sure you have all clutch plates engaged in their hubs completely.
 
OP
OP
Torkman66

Torkman66

Contributor
Sr. Member
Joined
Apr 3, 2022
Messages
854
Loc.
New Braunfels, Tx
Yes, gauge on tip of shaft and using large screwdrivers behind shell in front of rear planetary. I took it apart and changed the planetary washer to the smaller diameter one...no change. Pretty sure all the clutches are engaged...checked it several times. Just makes no sense. It was the same endplay prior to my rebuild.
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Stock rebuild? No extra clutches or anything unusual?
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
With the thrust washers in place, stack the direct clutch, fwd clutch, front planet and shell together on a flat surface and show us where the shell and direct clutch lugs meet (pictures). That will point to which half the problem is in.
 
OP
OP
Torkman66

Torkman66

Contributor
Sr. Member
Joined
Apr 3, 2022
Messages
854
Loc.
New Braunfels, Tx
Ok, so took it all apart back to the rev planetary (left clutch packs all assembled). Double checked the #1 plastic washer and it was the correct size...slid in between drum and pump but not sloppy. Put it all back together and measured endplay again...it is 12. No idea what the issue was. Did not change any washers or any position of anything. But appears to be in specs. Thanks for your support!! Now the Dana 44...ugh!
 
Top