• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Camber/caster measurements

pcf_mark

Bronco Guru
Joined
Jun 11, 2010
Messages
3,697
I do not, I'm more shade tree meets engineer. Buy a 12-14" digital level if you do not own one that has a magnetic base (Sears).

Take off your hub caps and put the level on the steel wheel. Make sure the surface is clean and you can get your level to sit vertically in the same spot repeatedly. You want to stretch across as much of the wheel as possible and get as close to the center as you can. Measure the angle - this is camber. Roll the vehicle forward and backward if you want to try it on several places in the wheel to verify your accuracy. My level reaches to wheel rim and is very repeatable - anything inside is a little sketchy.

With level still stuck to the wheel turn the wheel to full lock in one direction. Measure the angle (1.2 degrees for example). Turn it full lock the other way and measure the angle (2.2 degrees for example). The mid point of these two numbers is your caster (1.7 degrees).

Toe setting is really easy and there are a bunch of designs for trammel bars. I made a simple one from 1" copper pipe. Or you can do the thumb tack method. Stick a thumb tack into a treadblock at the front of each tire. Measure the distance between the two tacks (for example 56"). Roll the truck backward (so the tacks do not get run over) until the tacks are on the back side of the front tires where you can get your tape measure under. Measure this (56 1/4"). The difference (1/4") is your toe. Just make sure the number in the rear is bigger than the number in the front so you have toe in not toe out.
 

Digger556

Sr. Member
Joined
Aug 8, 2013
Messages
801
Those Longarce gauges are nice. I used one in college for the race car. We sell something similar where I work now. Lots of shadetree guys use them to do their own alignments and they work pretty well.

If I didn't have access to an aligner, that is what I would use.


The downside is that you are not performing a 4-wheel alignment, so if you have any thrust angle, axle-offset, or rear camber (bent housing) issues, the truck may still pull one way or the other even though the front is straight.
 
Top