Although I consider myself mechanically inclined, I never messed around with body work. And after searching google/youtube I am now a master;D. Joking.
Ol Barney has a couple rust spots that I have ground out and have bought POR 15 to stop it. The majority of the body is pretty straight with little or no Bondo. Im not looking for a showroom quality paint job, I just want to change the color of it and hopefuly next tax season I will have the money to pay someone to spray it but I want to do as much as the work myself as possible to save money and to say "I did it"
I know a lot of a good paint job is in the body work. I have a electic orbital sander that Im going to run over it to get some of the rough out of it (240 grit?) But I have read that block sanding is what needs to be done at the end. With that said I was looking at some block sanders from Eastwood that offer different contours in the blocks. And as you all now there aren't a lot of contours in our Bronco's. So this brings me to some questions.
1=Is my approach to sanding right? (orbit with 240 then go finer and end with blocks?)
2=When it comes to block sanders, do I need 7 different sizes or just one long one for all the flat panels? Or maybe one long one and one round one?
3=Im doing my sanding outside (no overhead lights) will I need some sort of light to see ripples or will a guide coat and block sanding do the trick?
Again I'm not looking on a Show room paint job like I see a lot of Bronco's on here, but I want to do the best I can with the little resources I have. Any tips or links will be great. Thanks
Here are the Blocks I was looking at
http://www.eastwood.com/dura-block-shorty-5-pc-kit.html
Ol Barney has a couple rust spots that I have ground out and have bought POR 15 to stop it. The majority of the body is pretty straight with little or no Bondo. Im not looking for a showroom quality paint job, I just want to change the color of it and hopefuly next tax season I will have the money to pay someone to spray it but I want to do as much as the work myself as possible to save money and to say "I did it"
I know a lot of a good paint job is in the body work. I have a electic orbital sander that Im going to run over it to get some of the rough out of it (240 grit?) But I have read that block sanding is what needs to be done at the end. With that said I was looking at some block sanders from Eastwood that offer different contours in the blocks. And as you all now there aren't a lot of contours in our Bronco's. So this brings me to some questions.
1=Is my approach to sanding right? (orbit with 240 then go finer and end with blocks?)
2=When it comes to block sanders, do I need 7 different sizes or just one long one for all the flat panels? Or maybe one long one and one round one?
3=Im doing my sanding outside (no overhead lights) will I need some sort of light to see ripples or will a guide coat and block sanding do the trick?
Again I'm not looking on a Show room paint job like I see a lot of Bronco's on here, but I want to do the best I can with the little resources I have. Any tips or links will be great. Thanks
Here are the Blocks I was looking at
http://www.eastwood.com/dura-block-shorty-5-pc-kit.html











