• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Drive line angle

WLDSTALLION

New Member
Joined
Jun 7, 2010
Messages
28
I am in the process of installing a zf and 205 along with a 1" body lift. I got in a hurry when taking out my old trans and did not measure the angle. Is there a proper way for setting the trans angle in there before I build my crossmember? Thanks Brad
 

Justafordguy

Bronco Guru
Joined
Sep 26, 2009
Messages
6,255
Not really sure there is some magic angle? If you use a drive shaft with a CV on that end it shouldn't matter all that much. It's the end that goes to the rear end that needs to be right. The amount of lift on the truck will make the most difference and will determine what pinion angle will work best. I would try to get the tranny/transfer as lined up straight as you can without having it hang down and cause ground clearance issues. Maybe one of the driveline shops would know?
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
The old angle wouldnt help you any. As your new setup is longer and the angle will be steeper no matter what. best case is you want a almost flat angle but with 4wd's, lifts and short wheelbase thats pretty much impossible.
Theres a tech article about pinion angle in the tech section that should help you out.
 

trailpsycho

Bronco Guru
Joined
Dec 11, 2003
Messages
4,856
As mentioned, just try to get the tranny as level as possible. You definitely dont want the end too low...as it will make the front driveshaft angle even more funky if the back of the tranny sits low. Good luck.
 

dbevans2249

Sr. Member
Joined
Sep 21, 2003
Messages
610
Loc.
Buena Park, Ca.
The carburetor mounting surface of the intake manifold should be level. You will find info covering that in many how to engine swap articles. Then you adjust the pinion angle as needed.
 
Top