I haven't seen anything on this for a while. Looking for a simple wiring scheme for dual batteries. No winch or big stereo. Race rig with intent to run on one battery and one in reserve. Thanks in advance! Mark...Gaucho Mark's Racing #66.
It's an interesting Engineering problem which has been solved numerous times in various ways.
I say it's an Engineering problem, because it is an exercise in compromise. There is no single best solution, and no one has come up with an clever solution.
The problem is that your reserve battery needs to recharge at a different rate than your primary battery. There is no work around for that. No combination of switches or diodes changes the fact that you can have one battery that is fully charged, and one that is completely discharged...and you need to recharge them differently.
(Note that this is totally different than running a pair of batteries in parallel. My Cummins, and my PSD have two batteries that are wired in parallel. That just increases the current capacity...but both batteries are at the same voltage at all times.)
Most people just run a diode bridge that prevents battery A from discharging into battery B, and vice versa. So you can have a single alternator that charges both batteries and prevents battery B from draining battery A. But of course if battery B is at 10V, and battery A is at 13.2V...then the alternator can't actually charge battery A until battery B comes up to 13.2V.
The best technical fix is to install two alternators. This is typically done for Ambulance service and RV's. It works.
What he said, saves me a lot of typing.
Adding charging diodes isolates the batteries and allows one alternator, but adds another point of failure that can take everything out.
I vaguely remember some marine alternators that are dual output. That is a group that wants reliability and redundancy as well.
Hey Mark, for all the race rigs and prerunner wiring we always use is dirt simple setup. A marine 4 position manual switch, mounted close to the driver. Been doing it that way for 20 years we have never had an issue. My favorite location is under the driver seat.
We never use relays or electronic dual battery setups. Reason NOT simple and way to many failure modes that racer hate. Do not over thing this setup - keep it simple.
Switch positions are 1, 2, both, off
Hey Mark, for all the race rigs and prerunner wiring we always use is dirt simple setup. A marine 4 position manual switch, mounted close to the driver. Been doing it that way for 20 years we have never had an issue. My favorite location is under the driver seat.
We never use relays or electronic dual battery setups. Reason NOT simple and way to many failure modes that racer hate. Do not over thing this setup - keep it simple.
Switch positions are 1, 2, both, off
Awesome replies. Thank you.
We’ve been using the marine 4 position switch the last couple of years but always seem to have one that dies. Just wondering if we had it wired correctly.






