• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

EFI and Backfire issues

FrankSG

Full Member
Joined
Sep 16, 2013
Messages
154
Loc.
Pittsburgh, PA
Guys

I just finished the build on my 5.0L H.O. After setting all of the usual timing, etc... It started just fine, but after it reached operating temperature it started to backfire, and had very little power. :(

One thing that did happen was that the O2 sensor connection was semi meted on the headers. After inspecting the wires I rebuilt the connector with a spare that I had.

Would a faulty connection / damaged sensor be the root of the problem? I know that seems like the obvious choice, but I wanted to see if there could be anything else I am missing.

How could I check the sensor and connection to the computer?

Here are the codes I received during KOKE:

327 EVP/EPT below min. Voltage
552 Air management circuit failure
565 canister purge, solenoid circuit fault
556 fuel pump relay primary circuit fault

(It has no EGR)

What does most of the mean or which ones have something that needs addressed?

Thanks,
Frank
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
Subscribing though. Not sure what would cause that on EFI after warming up. Some things that happen involve voltage at the wrong pin on the TFI module, but don't remember backfiring being one of them.

Backfiring through the exhaust presumably? Or is it spitting out of the intake?
Melted the O2 harness because it was laying on the exhaust?

What are the other particulars of this engine? Even though it's an HO, it was rebuilt, so could the cam be the wrong firing order?
And what type of cam is it, and if a flat-tappet, did you do a cam break in? I assume an HO to be a roller cam, but wanted to make sure.

Good luck. Let us know some more specifics though.
And instead of posting in in Tech again, maybe Jon can just move this one over?

Paul
 

ransil

Bronco Guru
Joined
Sep 6, 2003
Messages
8,138
vacuum leak
firing order wrong
timing AFU
low fuel pressure
Baro sensor connected to vacuum



post pictures of engine compartment
 
Top