How do I check or fix the carbon on chamber
Deposits in the combustion chamber raise compression, but so do other factors.
Since the cleaning process doesn't hurt anything (if done right), it's OK to clean it anyway.
With the engine FULLY warmed-up to operating temp, and at high rev (~1500-2500RPM), drip or spray clean (distilled is best) water into the throttle.
That's pretty much it. You want to get JUST enough water going in to make the engine cough, but NOT anywhere close to enough to hydraulic a piston. That's why the RPM has to be far above idle - so there's enough airflow to keep a puddle from forming anywhere, and then suddenly splashing into a chamber.
Just like when a head gasket leaks & allows coolant into a cylinder, the water starts to evaporate when it hits the hot metal. But when the piston compresses it, it liquefies again and is forced into the pores of any carbon deposits. When the cylinder fires, the water explodes into steam, blasting the carbon off. If there WAS any in your engine, you should see the exhaust turn dark initially, and then get whiter as you run out of carbon in the engine.
Keep it running long enough after stopping the water to be sure that no liquid water remains in the intake, and very little in the exhaust (there will ALWAYS be some there, even from normal driving).