I am going to give you something to think about... Having just done a Holley Sniper install on a 79 Trans Am, Pontiac 400 with a Tremec 5-spd behind it.
There were problems with the new unit, I spent conservatively 6 hrs on wait to talk to Holley Tech's, hung up twice after 1.5 hr waits, spoke with 3 of them in total, over the course of 3 weeks. I data logged with the unit, bought an SD card reader so I could send them data. That email went unanswered. (I have shortened this 3 month ordeal to this small paragraph) Finally the 3rd Tech I spoke with, on a Saturday, with a 40 min wait, when I started my call directly when they opened... After reviewing everything I had done or was asked to do, agreed with me that the IAC was bad, since I could not get the Sniper to idle at less than 1,100 rpm. Rather than send me a replacement part, He sent me a complete replacement unit that took two weeks to arrive.
So I say all this because once you buy into someones EFI unit, you are locked into them. No going to the local auto parts store for replacement parts, No putting on a scanning tool to see whats going on, No EFI guy, with a remote check, no going to the Ford dealer as a last resort, not putting something out on Classic asking for help. You might find a shop that has installed a number of units and is willing to tackle the problem, but what is their hourly rate?
I am not saying anything bad about Edelbrock's unit or Holley's for that matter... I am sure that there are many units that have been installed without issues??? But when things don't work, you are stuck dealing with whoever you bought from.
The end of my story... my good friend who trusted me with this project drove his car home over two weeks ago and is all smiles. I on the other had don't plan on doing another one of these conversions...