- Joined
- Aug 23, 2007
- Messages
- 24,451
I'm rebuilding a T shift D20. Background info is it was fine behind the original 3 speed trans. After the 435 was swapped in it developed a tendancy to pop out of rear high. Upon teardown it was obvious the rear shift fork had worn into the rear sliding gear about .070". Usually this happens when bungie cords are used or when the shifter interlock plate is mis-adjusted. The constant pressure on the shift rail pulls the fork into the gear. This looked more like a symptom of a temporary fix than the actual problem itself, although it will eventually make the problem worse. The splines on the input gear (where the sliding gear meshes in direct drive) also had a strange wear pattern. Probably because the sliding gear couldn't move forward enough.
Further cleanup revealed something odd with the 435 adapter. Looking down from the tcase end the 435 plate appeared to be off center. So I put the spud shaft together with a new bearing and set the adapter up to rotate on the spud shaft. Then I could clearly see the mis-alignment. With the holes being off center the spud and rear output shaft will not be aligned and I think that is the real problem. Here are a couple videos to illustrate the problem.
http://www.youtube.com/watch?v=JW8nK_L2j8I
http://www.youtube.com/watch?v=Uw0V-nbcAak
I'm going to replace the sliding gear, fork and input gear, finish the rebuild and recommend either a new adapter or having this one repaired. I don't see a problem with cutting the 435 plate off and having it welded back on, straight and centered.
Further cleanup revealed something odd with the 435 adapter. Looking down from the tcase end the 435 plate appeared to be off center. So I put the spud shaft together with a new bearing and set the adapter up to rotate on the spud shaft. Then I could clearly see the mis-alignment. With the holes being off center the spud and rear output shaft will not be aligned and I think that is the real problem. Here are a couple videos to illustrate the problem.
http://www.youtube.com/watch?v=JW8nK_L2j8I
http://www.youtube.com/watch?v=Uw0V-nbcAak
I'm going to replace the sliding gear, fork and input gear, finish the rebuild and recommend either a new adapter or having this one repaired. I don't see a problem with cutting the 435 plate off and having it welded back on, straight and centered.











