• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Fuel Sending Unit

lbbdoc

New Member
Joined
Sep 29, 2018
Messages
11
Probably a dumb question, but I'm new to this. I need to install a new sending unit, gauge checks out fine. I've installed them on a new tank, but never on a tank in use on the truck. Do I need to remove the tank, and/or drain it to be safe? I lost a good friend to a gas fire a long time ago and the stuff scares me big time. What do you guys do?
 

jckkys

Contributor
Bronco Guru
Joined
Mar 15, 2012
Messages
5,221
Why do you think you need a new sending unit? As to whether you need to drop the tank. That depends on what tank in what year Bronco.
 

Rightpace

Jr. Member
Joined
Aug 26, 2019
Messages
114
Get fuel out of tank, be prepared and get new hoses, disconnect the battery cable.remove tank, clean out gunk from inside tank. Reinstall new parts.
 

thegreatjustino

Contributor
Red Head Grease Monkey
Joined
Jan 23, 2002
Messages
16,291
Loc.
Stockton, CA
I've changed them numerous times with the tank still installed. Carry a full one gallon gas can with you. Drive around until you run out of gas. Put the one gallon of gas in the tank to get you home. With less than a gallon of gas in the tank, the fuel level will below the sending unit hole. Remove the locking ring, o-ring, and sending unit. Install new sending unit & o-ring, reinstall locking ring.
 

jckkys

Contributor
Bronco Guru
Joined
Mar 15, 2012
Messages
5,221
The only EB sending unit that needs the the tank dropped is the '77 main tank. The others can be done in place. You just have to do it with the fuel level below the hole.
 

papy

Contributor
Sr. Member
Joined
Jun 13, 2012
Messages
905
i just did this last week. i siphoned the fue out, disconnect battery remove old sender and pout in new one. i put light film of vaseline on the O ring (found this out on google) to hold it in place. tapped new lock ring in with a flat head driver - no fancy tools required.

no leaks and works as it should
 
OP
OP
lbbdoc

lbbdoc

New Member
Joined
Sep 29, 2018
Messages
11
Thanks guys, yes I should have stated it's a 68 factory main tank. The fuel gauge reads almost full until I have just a gallon or two left and then it drops very fast. I've been driving it that way for a long time, but would really just like to have a gauge that works correctly. I checked the gauge and wiring and it's good. Figure it must be the float on the sending unit. If it was a factory Ford unit, I'd try to rebuild it, but it's aftermarket. I think I'll go ahead and do it with the tank in place if it's not that dangerous. I know all the new sending units out there are Chinese, any recommendations?
 
Top