• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Full float, drive slugs vs drive flanges

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Another post got me thinking about this. The normal production full floating axle has a forged in flange with a lot of little bolts. This is normal. My F250 was this way. Even semi trucks are this way.
But the aftermarket has drive slugs. Which looks like a blanked out lockout for a front axle. I see this is very common for the aftermarket full float conversion.

Why a drive slug? I know why they exist for front axle applications. I don't know why they make them for rear axle applications? School me on this.
 

Quick & Dirty

Sr. Member
Joined
Feb 15, 2004
Messages
857
The bolt on 9" conversions use Dana 44 front axle spindle and hub parts. It's cheaper to use existing parts than to make a custom hub and drive flange. Handy if you flat tow, to freewheel the rear axle.
Alternately, weld on Dana 60 rear tubes and spindle and use the standard 60 hub and flange. The 60-9 hybrid axle. End up a little heavier, but stronger, than Dana 44 front parts.
 
Last edited:

brewchief

Sr. Member
Joined
Feb 11, 2007
Messages
877
I suspect part of it is cost, a 35 spline douple spline axle can be machined from a simple piece of bar stock( most likely in some expensive alloy), to make an axle with a flange you need to start with a forged blank and I suspect that to make a blank like that in some expensive alloys is costly.
FWIW there are companies that will make custom shafts with the full floating flange built in, IIRC only the 14 bolt end pattern fits though a normal 15" wheel and you have to use allen bolts to make that work.
Sent from my SM-T510 using Tapatalk
 

EPB72

Contributor
Bronco Guru
Joined
Jul 13, 2019
Messages
1,216
Loc.
Pleasant Hill, CA
So this is my experience with guys that have modified/ tuned there f250,, and duramax diesel trucks and then abusing them,, have seen one GM and 3 fords customers trucks towed in with broken Axles have all been on the drivers rear and there broken right at the flange… one of the Fords a Shelly,,the guy was doing 4wheel drive burn outs on pavement that truck makes a lot of power ..
 

Yeller

Contributor
Bronco Guru
Joined
Mar 27, 2012
Messages
7,692
Loc.
Rogers County Oklahoma
A few reasons.

First and foremost it is stronger, axles are happiest in extreme use with splines in both ends and the entire length of the shaft turned down to minimum diameter of the spline. Then use a high end alloy like 300m and you have a shaft that will take incredible abuse. It will also behave like a sway bar, it’s happily twists back and forth. You can’t get a flanged axle shaft to be as strong, you get into the same issues that you have with a semi float shaft, it’s just at a higher loads. Semi trucks pull it off just due to mass, those shafts are as big as some housings.

Another reason is cost. You can build and axle with 14 bolt or d60 front spindles and use a d60 splined hub. Of course you can use the 14 bolt hub. It’s all in what you want to do and your expected loads

To save a lot of typing there’s a good discussion about this here as well. More flanged axle discussion
 
Top