BulldogBronco
Full Member
- Joined
- Nov 13, 2018
- Messages
- 155
I put a holley sniper on my 302 a couple of months back and recently added the hyperspark ignition system which included the coil, the distributor and the ignition. When i drove it home from my mechanic in stop and go traffic, the RPM's went low and it died on me. It started right back up and I had no more issues. Then, I went to drive it yesterday and it struggled to start and ran awful. It was backfiring, stalling, etc. Even after I got it running after I let it run for awhile, it would lose power going down the road and seem like the throttle was pulling back. I'd like to try and fix it myself rather than get it towed to the mechanic, does anyone have any experience with the Sniper EFI and the Hyperspark ignition system? Or can anyone tell me what the timing should be at start (currently set at 15) and Wide open throttle (currently set at 32), and cruise (currently set at 35 or 36?). I checked the firing order and it is right. Could the issues be caused by the distributor being installed on the wrong stroke? Any ideas on why it would be running rough or tips on how to tune the system?











