• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Ignition switch brain fart

Waverous

Contributor
Bronco Guru
Joined
Oct 5, 2001
Messages
2,766
Loc.
Aurora, CO
See if I have this correct:

On the back of my ignition switch, I have tabs for Start and Ignition. If i remember right:
Start only has power during cranking
Ignition runs the coil after starting

Correct?
 
OP
OP
Waverous

Waverous

Contributor
Bronco Guru
Joined
Oct 5, 2001
Messages
2,766
Loc.
Aurora, CO
Thanks - just wanted to check before I wire up my HEI. Gonna take a wire from "Ignition 1" to the "Batt" side of the distributor and pigtail a wire to the "I" side of the solenoid.
Correct?
See how I snuck that second question right in there!
 
OP
OP
Waverous

Waverous

Contributor
Bronco Guru
Joined
Oct 5, 2001
Messages
2,766
Loc.
Aurora, CO
Thanks - just wanted to check before I wire up my HEI. Gonna take a wire from "Ignition 1" to the "Batt" side of the distributor and pigtail a wire to the "I" side of the solenoid to the "Batt" as well.
Correct?
See how I snuck that second question right in there!
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
The only problem I see is the ignition wire from the switch is a resistor wire. It may work ok but it may run at slightly less voltage. It depends on the resistance of the HEI unit. There may be a better wire you could use depending on the year of your harness.
 
OP
OP
Waverous

Waverous

Contributor
Bronco Guru
Joined
Oct 5, 2001
Messages
2,766
Loc.
Aurora, CO
I am removing the resistor wire and running a straight 12 volts to the HEI, which is what the instructions are calling for.

Thanks
 
Top