• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

lifter tapping

wesleydax

Full Member
Joined
Apr 12, 2011
Messages
331
What causes a hydraulic lifter to peck? Ok its not on a fomoco product, its a 68 baracudda 383. I just built the engine all new parts, crank, cam, lifters, valves, everything. it cranks and runs great but its got a lifter tapping on one cylinder. ive checked timing and its good, but if it was timing it would be all over not just the same one. any ideas? could it be a bad new lifter? thanks
 

bad 68

Sr. Member
Joined
Jul 1, 2010
Messages
930
Loc.
Northest Washington
I'm not familiar with that motor. Does it have adjustible rockers or are they non adjustible shaft mounted?

It is very posible valve lash is not in spec on that cylinder.

It is also possible a cam lobe has gone flat on that paticular cylinder.

It is also possible you have a bad lifter and won't pump up.
 

tacobronco

Jr. Member
Joined
Nov 15, 2011
Messages
97
It could be a bad lifter, but how long has the motor been running? In my experience it sometimes takes quite a while (1/2 hr?) and/or a full heat cycle to get all the lifters to pump up after a fresh build.
 
OP
OP
wesleydax

wesleydax

Full Member
Joined
Apr 12, 2011
Messages
331
non adjustable lifters, motor has ran about 20 min. just in shop no road time yet. would you just drive it for a while and see what happens?
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Might want to check and see if you can find out which one is tapping. Maybe check the pushrod lenght or for any thing thats abonormal with that rocker arm.
Kinda depends on how loud your tapping is on wether ot not you should drive it if it sounds loud it might not be a good idea.
While it can happen that lifters dont pump up its kinda unusual for them to not to pump up on fresh oil. but it could happen if its not ticking to bad then run it some more.
As others said could be a bad cam lobe, bad lifter, worn lifter bore that has to much clearance and is not allowing the lifter to pump up. New valves? well maybe one was ground wrong. Did you use new or old pushrods? a old one could have excessive wear or a new one could just be made wrong.
All kinds of things can cause the issue unfortunetly its not always easy to pin down the issue.
 
Top