Well not a whole lot done on it today.
I looked at the steering shaft and hit a snag, stepped back had a beverage and found a solution.
The angle from the steering box input to the end of the column is to steep for the flaming river u joints. It would bind badly. So the solution is to cut the end of the column off and weld it back on removing a few inches of column that I do not need. This will give me more angle to work with on the steering shaft and u joints. There are two marks on the column in the picture, the upper one is where the column would end, the lower mark is the amount of column end I need to keep for the bearing.
I figured that I would just weld in a chunk of tubing to give the mount its strength back.
The inner fenders are coming out as well, I do not know how much of them I will end up with if any. Just need a little more tire clearance on compression.
Also it looks as though I will also need some wheel spacers for the front. The rims and tires are set to far inside with the 56" wheel base crossmember.
This will also help with the rims hitting the a arms.
The other pic is well just where it will sit for some time now. Had to drive the other one today as I needed to make the tires round again.