661buster1963
Full Member
- Joined
- Feb 18, 2009
- Messages
- 309
Have come to the conclusion my early bronco has too many man hours and blood sweat and beers in it to take much off-roading. I have looked at transmission options and really only considering manual transmissions (if nothing else 90% can’t drive it). Since off-roading is off the table, makes dead first gear off the table too (I fully understand why it’s desirable if you off-road, but really not if I don’t). The ax-15 and NV 3550 look nice but at some point may just have too wide a gear ratio (and cost) option based on my loose goal of:
1) getting 800 rpm min at 5 mph in lowest usable gear, and
2) getting 3000 rpm max at 60-65 mph at highest useable gear
I see the T19’s has a 4.02, 2.41, 1.41, 1.0 option that would seem to meet 1 and 2 with 35” tires and 4.11 gears or even 4.56 gears. I also see a not often talked about NP435 option with 4.56, 2.28, 1.31, and 1.00 gears. A wide gap between 1 and 2 but not as wide as some.
Anyone run the T19 with 4.02 first gear and have feedback on how it works out? Seems just wide enough a range between 1st and 4th to meet my goals and I see one local for 225$
The stock 3 speed has roughly a low gear minus high gear value of 1.99, hard to get the two goals above.
The NP435 I have on the bench with granny low as a low useable of 3.34 and high of 1, so the low minus high is 2.34: better but still tough to get the goals noted. Really need low useable gear minus high gear to be about 4 or more. The two Jeep trannies low usable minus high are 3.04 or more, possibly too high to use both 5th and first??
Any critical flaw in this thought process?
1) getting 800 rpm min at 5 mph in lowest usable gear, and
2) getting 3000 rpm max at 60-65 mph at highest useable gear
I see the T19’s has a 4.02, 2.41, 1.41, 1.0 option that would seem to meet 1 and 2 with 35” tires and 4.11 gears or even 4.56 gears. I also see a not often talked about NP435 option with 4.56, 2.28, 1.31, and 1.00 gears. A wide gap between 1 and 2 but not as wide as some.
Anyone run the T19 with 4.02 first gear and have feedback on how it works out? Seems just wide enough a range between 1st and 4th to meet my goals and I see one local for 225$
The stock 3 speed has roughly a low gear minus high gear value of 1.99, hard to get the two goals above.
The NP435 I have on the bench with granny low as a low useable of 3.34 and high of 1, so the low minus high is 2.34: better but still tough to get the goals noted. Really need low useable gear minus high gear to be about 4 or more. The two Jeep trannies low usable minus high are 3.04 or more, possibly too high to use both 5th and first??
Any critical flaw in this thought process?











