Yesterday, I finally got back to the headliner. Experimenting with the J Cap material, brought to my attention by member, .94 OR. I started with one of the short sections of the front headliner section. The liner mounting flange in my situation required a lenght of J Cap, 22 3/8" long with three mounting holes.
The original thought was to mount the J Cap's long width (1") between the liner and the hardtop. And using the shorter 1/2" side as the exposed edge. This did not work out for me. Because the pre existing holes in the liner were not the same distance from the edge of the liner. And they were not far enough from the edge of the liner. To place the clearance hole in the J Cap, to allow clearance for the fasteners head. With out a clearance radius in the short section of the J Cap. So to make it work as first planned. I would have to slot out all the holes in the headliner material to place the hole in the J Cap. Away from the short side lip, for bolt head clearance. Here are a series of pictures showing the hole location variance with in this J Cap section.
I used the headliner material to transfer the hole locations to the J-CAP. Because those holes were used to locate the nutserts in the hardtop. I used my milling machine to drill and clearance the short lip of the J-Cap. Seeing this variation in hole locations. It was decided to use the long side of the J-Cap, as the exposed side. Which looks just as good and the hole location variation isn't that noticeable. The clearance radius is still needed, to clear the nutserts diameter.
I do like the finished edge much better than just the wavy edge of the ABS headliner material. Worth the added time and expense? I think so. More to come as I get to the rear section of the headliner.