• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

shifting converted floor three speed

67RT

Bronco Guru
Joined
Jan 17, 2014
Messages
1,308
I do not know the tranny history on truck. Motor was rebuilt at some point. Drives well. Slowing down shifting from third to second not easy and noisy unless I double clutch it and do very slowly. Going back into first can be a challenge as well. Shifts first to R , second and third no issue. Shifter linkage looks well greased. I am not sure what it is supposed to look like. Maybe synchros in trans or shifter needs a rebuild? Anyone have a similar issue.
 

Jebus

Full Member
Joined
Feb 13, 2011
Messages
303
Loc.
Longview, WA
Is the clutch adjusted properly?
Is your clutch releasing all the way when put to floor?
Maybe a "grabby" pilot bearing/bushing.
Is the shift linkage spot on in neutral?
Is the trans full of clean lube?
Yes, given the high mileage of a stock original three speed, the synchronizers and blocking rings could be just worn out.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
Clutch adjustment as well for my first choice.

I once had one that was nearly identical to your condition. I could get the clutch to release but not fully engage, or fully engage but not fully release. Found the linkage wear/body mount condition had the equalizer bottoming out on the frame. Had to shorten the rod through the floor to make it work. Hopefully yours is just an adjustment.
 

Timmy390

Contributor
Bronco Guru
Joined
Jan 1, 2011
Messages
5,948
Loc.
Conway, AR
Does it shift OK without using the clutch? No I'm not crazy.....

While driving along, take your foot off the gas, pull it out of gear and then hold a small amount of pressure on the stick as if you were going into the next gear. Let the rpm's fall and as they do, it SHOULD drop right in gear. Sometime a tap of the gas will be needed depending on where you are in the RPM band.

If it shifts fine when doing this then it's clutch related for sure.

Tim
 
OP
OP
67RT

67RT

Bronco Guru
Joined
Jan 17, 2014
Messages
1,308
Ok, just took for first major shake down run. 80 miles to and from MVA inspectors. I did get the feel better for shifting it, but it still seems cranky and upon decel, especially in 3rd gear coming down from 55-60mph there is a noise coming from down there, maybe throw-out bearing?

I have never adjusted a clutch. Will have to look into that. Any links? I am sure I can find it on google.

All and all, a victorious maiden voyage. I was nervous since I have never had it on the highway and have only driven it 10 miles since owning. No drips in the driveway, no smoke from tailpipes, no wavering in the lane, no pulling drum brakes. Just loud. Headers and a hole behind driver muffler and steel floor.
 
Top