Speedometer Drive Gear

[redwards69]

I need the spiral gear that goes on the output shaft. I cannot find the one from disassembly, maybe it wasn't in there. Anyone know where to buy one? I dont see them on any of the vendor sites. Is the Jeep version for a D20 the same?

 

[blubuckaroo]

Call Tom's Bronco Parts. Even thought heir catalog is pretty complete, they have a lot of other stock, and the advice to go with it.

 

[Viperwolf1]

I need the spiral gear that goes on the output shaft. I cannot find the one from disassembly, maybe it wasn't in there. Anyone know where to buy one? I dont see them on any of the vendor sites. Is the Jeep version for a D20 the same?

I believe the jeep ones are reverse cut. It must have been in there or you couldn't preload the rear bearings.

 

[redwards69]

I believe the jeep ones are reverse cut. It must have been in there or you couldn't preload the rear bearings.

Good point, thanks Viperwolf. I never drove the truck before dismantling it completely for a full rebuild.

Call Tom's Bronco Parts. Even thought heir catalog is pretty complete, they have a lot of other stock, and the advice to go with it.

Thanks blubuck, I'll call them Monday.

 

[Casey4wd]

I think WH has them:

http://www.wildhorses4x4.com/product/Speedometer_Drive_Gear

 

[Viperwolf1]

I think WH has them:

http://www.wildhorses4x4.com/product/Speedometer_Drive_Gear

That is actually the driven gear. The OP needs the drive gear (meshes with the driven gear).

 

[Casey4wd]

You are correct. Disregard the link I posted.

 

[redwards69]

Toms had a 6 row metal one, said it was only one they had. Cost me $38. Ugh.

 

[Viperwolf1]

The one piece steel ones are better. The plastic ones can slip off center.