Revelation
Bronco Guru
- Joined
- Oct 9, 2004
- Messages
- 4,815
I'm shocked ...ypu didn't reccomend stainless......
With the current economy I figured I would save him a few cents. But he could also use these. I would on mine.
Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Suggestions for sealing holes in the cab
- Thread starter Accordngs
- Start date
With the current economy I figured I would save him a few cents. But he could also use these. I would on mine.
OP
OP
Accordngs
Jr. Member
I like this idea. I have always been intrigued by POR15 and since that is the same stuff in a tube....sounds great. I am going to put an order in now.
I think I am only going to use it on the drilled out holes in the cab. I am going to leave the threaded holes alone just in case I ever want to put a rear seat in...or stock fronts back in.
