• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

testing temp gauge?

73stallion

Bronco Guru
Joined
Mar 5, 2004
Messages
16,786
Loc.
Eugene, OR
anybody know a trick on how to test the temp gauge in the cluster? i have a gauge not working, already replaced the sending unit. wanna test it before i pull the cluster to replace it.
 

4x4man514

Contributor
Bronco Guru
Joined
Aug 28, 2003
Messages
1,157
Loc.
Augusta,Georgia
if you ground out the sender wire the gauge should go to the highest temp. if it does nothing the gauge is bad or there is an issue with the wiring.
 

oleguy74

Contributor
Bronco Guru
Joined
Mar 26, 2008
Messages
2,034
Loc.
calif city ca
temp is same as fuel gauge.so is oil pres. 73ohms about 120*,21 ohms is 195*,10 ohms is 230*.gauge res is 10-14 ohms with all wires removed.
 

00gyrhed

Bronco Guru
Joined
Aug 3, 2006
Messages
2,428
easy test before you install the sending unit. wrap a wire around the body of the unit to ground it. boil some water and drop the grounded sending into the boiling water. the gauge should read whatever temperature water boils at your altidude. 212 on the coasts and maybe as low as 180 in the mountians.
 

brianstrange

Bronco Guru
Joined
Nov 22, 2011
Messages
1,626
easy test before you install the sending unit. wrap a wire around the body of the unit to ground it. boil some water and drop the grounded sending into the boiling water. the gauge should read whatever temperature water boils at your altidude. 212 on the coasts and maybe as low as 180 in the mountians.

+1 ......if you're not getting a reading, check your coolant level or for an air pocket in your cooling system. If that's ok, make sure you have power and a good signal at the gauge. I've seen people tap sensor wires for aftermarket equipment grounds... A cheap $10 meter will help you check continuity and voltage.
 
OP
OP
73stallion

73stallion

Bronco Guru
Joined
Mar 5, 2004
Messages
16,786
Loc.
Eugene, OR
sounds like it'd be easy enough to hook the wire to the fuel gauge and test it that way, i'll do that tomorrow. thanks oleguy
 
Top