• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Transfer case question

Bronk74

Sr. Member
Joined
Sep 1, 2004
Messages
414
Loc.
North Las Vegas
I’m planning on fabricating a bracket to mount onto the transfer case to attach to my floor Jack so I can remove/ install more easily. Any suggestions would be appreciated. I’m trying to figure out the Angel it sits at. If anyone know please comment thanks.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
No help here, because I always did it the awkward way. Just trying to balance it on the top of the jack.
I think you’re going about it the correct way and trying to make a proper mount.
Interesting to see how it proceeds.

I know a lot of people have talked about doing the transfer case using special mounts or a dedicated transmission jack, but I don’t remember seeing any pictures here of special fixtures anyone made.
But I bet somebody’s come up with something.
Good luck!
 

bax

Contributor
Old Member
Joined
Aug 22, 2005
Messages
14,552
Transfer case is a pretty easy install. Just press it up there and stick it. Easier than messing with a jack. However its you want the answer, Just set your cell phone to measure and put the edge of it on the inspection cover. It will give you the angle.
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,111
I once made a quick adaptor for a floor jack. Pure scrap. A "hand" to hold the front output and a "stick" to hold up the rear output. Wobbly is great as you can shake it into alignment. No measurments, just use stuff that is handy and "about right" and go for it.
 

mrdrnac

Contributor
Sr. Member
Joined
Feb 6, 2010
Messages
577
I made a cradle out of wood for mine and attached it to my trans jack, worked great but was probably overkill for what was needed. But sure made it easier when working alone.
 

Attachments

  • Transfer Case Cradle.jpg
    Transfer Case Cradle.jpg
    111.6 KB · Views: 115

Timmy390

Contributor
Bronco Guru
Joined
Jan 1, 2011
Messages
5,948
Loc.
Conway, AR
I made a cradle out of wood for mine and attached it to my trans jack, worked great but was probably overkill for what was needed. But sure made it easier when working alone.
I did the same thing. Works GREAT

Tim
 
Top