• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Trouble removing drum backing plate

crutch

Full Member
Joined
Jul 3, 2015
Messages
249
I'm doing a drum to disc conversion on the front and I'm having a hell of a time removing the drum backing plates on both sides. I removed the six screws that attach to the spindle but it's not budging. Am I missing something? Any tips! A couple photos attached. Thanks!

ea388b8c92e76adccc9b04018e9ceb01.jpg

8698311a5869fc871e239235c9eb41b0.jpg



Sent from my iPhone using Tapatalk
 
OP
OP
crutch

crutch

Full Member
Joined
Jul 3, 2015
Messages
249
Of course after posting this I got one to come off. It took quite a bit more of sledge hammer then I was expecting.


Sent from my iPhone using Tapatalk
 

Steve83

Bronco Guru
Joined
Jul 16, 2003
Messages
9,360
Loc.
Memphis, TN, USA, Earth, Milky Way
The inboard side of the spindle flange (bottom of this pic) has a pilot that fits tightly in the steering knuckle:



...when it's CLEAN. When it's dirty &/or rusty, it's an interference fit, which is what you're discovering. There IS a slide-hammer adapter made specifically for pulling them, but it's generally too expensive for someone maintaining only 1 vehicle to justify buying.

So when you get them out, wire-brush the pilots AND bores thoroughly to remove all rust & dirt, and then apply anti-seize lube during assembly.

You should also thoroughly clean the rest of the spindle; to keep the bearing grease clean, and to prevent damage to the new (right?) inner seal.

 
Top