What have you done to your Bronco today?

[broncoman1972]

Fixed a ground to my new MSD that got pinched off while Zack was driving the Gorge at HS.

 

[sprdv1]

Took it for a spin to the store

 

[daddycreswell]

Nothing for 2 weeks, a buddy of mine has it to look over somethings, and rebuild carb. While he is fighting the rain to do his hay. I could have learned how to rebuild the carb myself by now.

Sent from my SPH-L710 using Tapatalk 4 Beta

 

[tcb-1]

Replaced clutch and accelerator rod boots, cleaned about a pound of leaves and dirt out of each air intake. Searching the brake warning light gremlin..... looks like it's been unconnected for years.

 

[Pat'sBronco]

Took the heads and oil pan off. Found one of the bear cap bolts in the bottom of the oil pan! ?:?

 

[tatersalad]

gave her a much needed wash and wax..

 

[matt w]

I put new Rancho 9000's on the front of my truck and to my surprise (I thought they would be white!) they match my cage, tube doors and bumpers exactly! Now I look like the poser I am!

The only bummer is that now to complete the full poser package I have to purchase a pair for the rear! ;D

 

[BronCowie]

Patched another hole in her body today... I think I'm gaining ground.

 

[Tedster100]

Drove it! Took my daughter and two nices for a ride around the lakes.

 

[JustinFro]

Over the weekend...

1. Drove 100 miles one way to see family in OKC
2. Discovered pin-holes in trans pan; had the pan brazed at local muffler guru
3. Installed bikini top
4. Installed grill trim; mocked up side trim and cleaned (awaiting install)
5. Installed wiper-motor cover and sun-visors
6. Installed new front bumper (pre-runner style)
7. Attended monthly Cars & Coffee event (Only Bronco there; some cool FJ40s there too)
8. Discovered leak of motor oil from valve cover; turns out the PO did not install a gasket under the filler cap
9. Topped off radiator coolant
10. Drove 100 miles back to Tulsa

*Put about 300 miles over the entire weekend. Great time, but at 9-10 mpg... ugh

 

[Tedster100]

Took the heads and oil pan off. Found one of the bear cap bolts in the bottom of the oil pan! ?:?

That can't be good....

 

[ahansen_1985]

Drove it up to Oregon city and mciver state park again, went kayaking w some buddy's, 80 miles on the bronco, 30 on the kayak!


1966 bronco, almost nothing factory

 

[miikee73]

Drove it to work today...trying out the AC

sent from my fart smone using crap talk

 

[lonesouth]

installed the twin stick last night. Fixed my trans leak the night before.

 

[Lmfp]

Put in the transmission, transfercase, driveshafts, throttle cable, trans fluid, and gear oil and fired that baby up!!!

 

[BroncKrawler]

Got my new third member installed today from Tom's Bronco Parts, gotta break this baby in! 4.88s, 31 spline Yukon Grizzly locker, and new 31 spline shafts. Next up is 4.88s and an OX locker for the front!

 

[ahansen_1985]

Got my new third member installed today from Tom's Bronco Parts, gotta break this baby in! 4.88s, 31 spline Yukon Grizzly locker, and new 31 spline shafts. Next up is 4.88s and an OX locker for the front!

Very nice Andy!

 

[Z Bronco]

Finally got to work on the bronco. Test fit my EFI tank and will need to do some grinding off some remnants of an old receiver hitch that was welded to the frame. Will move some wiring as well to help with clearance. Put the skid plate on to see how high I can mount the tank. Fun!

 

[daddycreswell]

Got the passenger side seat out, and got 2 sets of covers and old foam off the frames. Primed and painted the seat frames. Now I have to see if I have enough smarts to put new covers on. I'm not feeling to good about it, but am going to give it a try.

 

[Golfball]

Drove it!!! Put about 20 miles on it after the tranny and t-case rebuild and power steering install. It was down for almost three months, way too long.