What have you done to your Bronco today?

[romerdoug]

Got the new painless harness finished but didn't have time to test it. I was hoping to get it done today so the boy and I could play in the snow but my wife had other plans. She should be back on the road tomorrow, hopefully there is still some snow to play in!

 

[smokinjoe]

Tacked, tacked, and tacked. Patch panels baby!

 

[romegadave]

Got fuel pump on but having a fit over getting bottom bolt in ps pump bracket:-X---will bench the master c today and install tank late this week

 

[Lon L]

Picked this up from Powdwer Coating

Picked this up from Powdwer Coating

 

[Ol'Blue]

Finally got engine dressed up, painted engine bay and hydroboost done. I think it turned out pretty nice. Some before and after.

 

[miikee73]

Finally got engine dressed up, painted engine bay and hydroboost done. I think it turned out pretty nice. Some before and after.

Wow ,looks like a different truck. Glad to see you did something with the scoop screws,that's where my eyes went first in the before pics.

 

[Faster Eddie]

Counted my speedo gear teeth and ordered what I think/hope I need to fix my 25% variance

 

[SpareParts]

Finally got around to installing my new intake set up...

 

[sprdv1]

Vroom Vroom..

 

[5001craig]

Picked-up my 35 spline Grizzly locked drop out.

And checked on the engine build.

 

[Mtgrizzlymn]

Drove to town 50 miles got to use my new steering wheel and retro radio

 

[JAFO]

Finally got around to installing the new visors and tach last night that the wife got me for Christmas.
Tach is mounted and I have the wires connected to the tach, but still need to do some wiring under the dash.
Also night before I fabricated some rock guards that I attached to the wheel wells to stop rocks from hitting the underside of the fender. Just used some angle flashing I had. Used SS screws and then coated under all the wheel well with rubberized undercoating. Will see how that does.

 

[smokinjoe]

Cut out some quarter panel

 

[romerdoug]

Finished wiring the 12V power socket, USB ports, heated seats, led dome light and led license plate light. The new painless harness made this really easy.

 

[toddsrods]

fixing the exhaust i smashed a couple weeks ago so i can go on the run with the local Bronco club tomorrow!

 

[Z Bronco]

Welded in the upper rear shock mounts. Mission is to get the Bronco running by summer.

 

[KungFuPanda]

Will not crank

I was able to jump from the battery to the red post on the starter relay and get it to crank. I pulled out the ignition switch because it felt a little spongy. I then jumped between the yellow hot wire and the red wire on the back of the switch. I checked for voltage at the relay and I had voltage but it still wouldn't crank. So i jumped it again from the battery and the red wire on the relay and it cranked. Maybe i am loosing some voltage from the switch to the relay or the relay is getting weak. Any help would be appreciated. By the way it is an automatic and I believe the neutral saftey switch is working because I am getting voltage to the relay.

 

[smokinjoe]

^^^ Post this as a new thread in 'bronco tech' Panda. you'll get a lot more looks and advice. Unfortunately you stumped me but that's not very hard

 

[smokinjoe]

Patched some rot and POR15'd the inner fenders. Lot of work for something no one sees

 

[nickgp]

Sliced off the bottom of the tailgate in order to weld in a patch panel and diced up the drivers side quarter for a stock fuel door on our 66 mod.