Gary,
You would not happen to have any pix of that old setup would you? How did it attach to the rollbar? The allthread that I selected is 3/8 thick, and I was thinking about flexing, but it seems pretty rigid, and I am thinking any added pressure will only make it more so...I think conduit with foam my look better than allthread though...
Thanks for the input...
R
Sorry, looked to see if I had a pics that showed the set up but could not find anything. I attached it to the roll bar with a 5/16 bolt attached to the end of the conduit and then threaded into a tapped hole in the roll bar. Sounds funny but I used a plumbers rubber pipe plug to attach the bolt to the end of the conduit so it stuck straight out - the kind of plug that expands the rubber when you tighten the bolt. Hard to explain but it worked fine as a ws frame support! The rubber actually allowed a little bit of give which was probably a good thing.











