FunSeeker
New Member
Hello Fellow Early Bronco Nuts,
My '75 has a serious door pillar problem, the Front Door Pillar to Cowl Rear Brace that is welded to the top of the Front Door Pillar is too far away from the door's window frame, by about 1/2" worst case on passenger side, a little less distance on driver's side. When the doors are closed, there are gaps between the door seals and the windshield mating edges (the back sides of the windshield rain gutters). These gaps taper off to zero at the top of the windshield where it mates with the hardtop. So, my tub leaks rain. The door hinges seem good, but there is too much gap between the front edges of each door and the back edge of each front fender, especially on the right. I noticed that the windshield hinge is not attached to the body for at least half of its length from the passenger side in, so I believe a previous owner has probably replaced the door pillars, braces, windshield frame, etc. and not lined up the parts correctly before welding. Do I need to disassemble the tub and re-do the front door pillars, braces, etc. to get the doors, fenders, windshield frame, etc. all line up properly, or is there a better way to make my tub right?
I don't know how to post photos here, but you can email me at cnc_dog@yahoo.com and I can send photographs.
Thanks for the help, bewildered in San Jose, CA. Does anyone know of an early bronco body specialist in the San Francisco bay area?
Thank you, Jim
My '75 has a serious door pillar problem, the Front Door Pillar to Cowl Rear Brace that is welded to the top of the Front Door Pillar is too far away from the door's window frame, by about 1/2" worst case on passenger side, a little less distance on driver's side. When the doors are closed, there are gaps between the door seals and the windshield mating edges (the back sides of the windshield rain gutters). These gaps taper off to zero at the top of the windshield where it mates with the hardtop. So, my tub leaks rain. The door hinges seem good, but there is too much gap between the front edges of each door and the back edge of each front fender, especially on the right. I noticed that the windshield hinge is not attached to the body for at least half of its length from the passenger side in, so I believe a previous owner has probably replaced the door pillars, braces, windshield frame, etc. and not lined up the parts correctly before welding. Do I need to disassemble the tub and re-do the front door pillars, braces, etc. to get the doors, fenders, windshield frame, etc. all line up properly, or is there a better way to make my tub right?
I don't know how to post photos here, but you can email me at cnc_dog@yahoo.com and I can send photographs.
Thanks for the help, bewildered in San Jose, CA. Does anyone know of an early bronco body specialist in the San Francisco bay area?
Thank you, Jim











