• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

amp meter problem

nyhillbilly

Full Member
Joined
Sep 22, 2006
Messages
173
Loc.
Canton, MI
My amp meter seems dead, I installed a new alternator, voltage regulator, and centech full truck harness, the voltage checks good to the VR,

my oil pressure and engine temp work, along with all lights, my fuel tank rears empty when i know its full,I am not sure if the IVR has anything to do with the temp or pressure gauges.

so my question is does it sound like the instrument VR is bad or the individual amp and fuel gauge have a problem?
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Fuel gauge circuit has a problem. IVR powers temp, oil and fuel gauges. Ammeter is stand-alone and needs the main power wire to be routed through the loop on the back to work.

You can check the fuel sender and ground by shorting the sender wire directly to ground. This should cause the gauge to read max.
 
OP
OP
nyhillbilly

nyhillbilly

Full Member
Joined
Sep 22, 2006
Messages
173
Loc.
Canton, MI
Fuel gauge circuit has a problem. IVR powers temp, oil and fuel gauges. Ammeter is stand-alone and needs the main power wire to be routed through the loop on the back to work.

You can check the fuel sender and ground by shorting the sender wire directly to ground. This should cause the gauge to read max.


ammeter has the 10 gauge running through the loop on the back of the gauge, the needle was bouncing around some but now just stays in the middle position. Is it common for the gauge to go bad?
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Middle position is normal for a fully charged battery. What does it show just after starting?
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,112
My amp meter seems dead, I installed a new alternator, voltage regulator, and centech full truck harness, the voltage checks good to the VR,

my oil pressure and engine temp work, along with all lights, my fuel tank rears empty when i know its full,I am not sure if the IVR has anything to do with the temp or pressure gauges.

so my question is does it sound like the instrument VR is bad or the individual amp and fuel gauge have a problem?

When the harness was installed did they routh the main battery feed wire through the ampmeter? If they didn't that is the problem.
 

travis77

Full Member
Joined
Feb 9, 2009
Messages
324
Loc.
Pasadena MD
If it bounces around in the middle, that sounds just right. If it strays a long way from the middle, then you have a problem. Leave the radio and the lights and heater on with the engine off. If it drops, guage is good. Then start the engine, if it goes up, all good.
 
Top